2014 Mazda 3

[chiezee]

Need to get rid of that wheel gap soon 😂

[Geo_S]

Need to get rid of that wheel gap soon 😂

Htech is the solution bro! 😂

[chiezee]

Htech is the solution bro! 😂

Yes bro after i go back to manila for my 10k pms.
Btw do you know anyone who is good at fixing my rock chips? I got 3 atm at my front bumper, not noticeable though. Baka kasi dumami na pag 10k km.

[justdiy]

Yes bro after i go back to manila for my 10k pms.
Btw do you know anyone who is good at fixing my rock chips? I got 3 atm at my front bumper, not noticeable though. Baka kasi dumami na pag 10k km.

Already went through the plastic? Do you have pics sir? You can either retouch with nail polish or mazda's touch-up pen. to avoid additional chips in the future, you should install a clear bra. Sir Manskee knows and recommends a good installer in Santolan, Near GH.

[travajante]

Yes bro after i go back to manila for my 10k pms.
Btw do you know anyone who is good at fixing my rock chips? I got 3 atm at my front bumper, not noticeable though. Baka kasi dumami na pag 10k km.

+1 on what Mast3r Technical Detailer justdiy said....Just DIY em w/ Mazda Touch Up Pen. Follow these clear steps.
https://youtu.be/sJ01Gb1pmyU

[Geo_S]

Yes bro after i go back to manila for my 10k pms.
Btw do you know anyone who is good at fixing my rock chips? I got 3 atm at my front bumper, not noticeable though. Baka kasi dumami na pag 10k km.

I also have two pero napakaliit lang. Di talaga maiiwasan eh, kahit na parang may film ung bumper natin. Try touch up pen first bro. Im sure you don't want the whole bumper repainted because of small rock chips.

[Doctsakititoy]

Can i request a picture of the stock dual exhaust setup of the M3 2.0?
Thanks in advance!


Sent from my iPad using Tapatalk

[chiezee]

Already went through the plastic? Do you have pics sir? You can either retouch with nail polish or mazda's touch-up pen. to avoid additional chips in the future, you should install a clear bra. Sir Manskee knows and recommends a good installer in Santolan, Near GH.

Ill take a picture of it tomorrow bro. How much do you think this clear bra cost? I might need it madalas sa highway route ko daming trucks dami pang inaatos na kalsada

[chiezee]

I also have two pero napakaliit lang. Di talaga maiiwasan eh, kahit na parang may film ung bumper natin. Try touch up pen first bro. Im sure you don't want the whole bumper repainted because of small rock chips.

Oks sir. D kasi ako naka pag order may nag post murang touch up pen sa fb group ☺.

[travajante]

Can i request a picture of the stock dual exhaust setup of the M3 2.0?
Thanks in advance!


Sent from my iPad using Tapatalk

It's just a mirror of your right exhaust tip, good doctor sir. The stock 1.5 exhaust box is the same as the 2.0 except for the left hole being plugged shut & a smaller flange at the straight pipe joint.
If Racing Beat would interest you, I appeal for a lil patience. RBs are built in the U.S., used by Mazda for the SEMA Clubsport3 & the SEMA MX5s. Advantages? Looks, sound & slight gains on power & torque. Here's their Dyno chart on a 2.0:

These are direct bolt on kits that fit the 2.0 & 1.5. The latter will need slight filing of flange bolt holes since the 1.5 has a smaller flange but lines up identically w/ the 2.0. This was the only lil tweak I did. All hangers are stock. Tips practically need no massaging for alignment. Install takes less than an hour for adept hands.
Here's a buttshot of BlackMouth's RB....

A few sets will be shipped here soon by a Mown3r buddy. Price is yet TBD. Updates will be shared here, of course. Thanks!!!!

[Doctsakititoy]

It's just a mirror of your right exhaust tip, good doctor sir. The stock 1.5 exhaust box is the same as the 2.0 except for the left hole being plugged shut & a smaller flange at the straight pipe joint.

Ah, I suspected as much! Thank you once again, James!

[travajante]

Ah, I suspected as much! Thank you once again!

AnytiM3, good doctor sir! Am I sensing surgery?

[Doctsakititoy]

Trying to determine a clear indication for surgery! ;)


Sent from my iPad using Tapatalk

[travajante]

Trying to determine a clear indication for surgery! ;)
Sent from my iPad using Tapatalk

It's not difficult. Left bumper cover is just held by 1 screw. All you need is a 90° bent 304 Stainless pipe & an extra identical tip or 2. Weld away. Removing the left plug is optional. Left tip can remain a dummy or can actually function...the good doctor's call.

[Doctsakititoy]

I'd probably get a functioning exhaust tip. I'd imagine this will be a hobo mod?


Sent from my iPad using Tapatalk

[travajante]

I'd probably get a functioning exhaust tip. I'd imagine this will be a hobo mod?
Sent from my iPad using Tapatalk

Yup, hobo. Thought about it. Even stored an extra custom tip w/ pipe in the trunk since long ago,

....but an RB fell from heaven. Grateful & can't refuse, can I?

[Doctsakititoy]

So that is still unused and probably will stay unused, eh?


Sent from my iPad using Tapatalk

[travajante]

So that is still unused and probably will stay unused, eh?
Sent from my iPad using Tapatalk

Honestly? It's of the same diameter.....not an exact clone, a bit too polished. Might be good enough for others but not our OCD, doc. Haha

[xhrenz]

Anong variant ng mazda 3 skyactiv yung meron ng reverse camera at navigation?

Sent from my ASUS_T00J using Tapatalk

[Yatta]

Anong variant ng mazda 3 skyactiv yung meron ng reverse camera at navigation?

Sent from my ASUS_T00J using Tapatalk

TOTL ang may camera yata. Yung navigation wala pa rin and no info on when MazdaPh will release it or if ever.