the only engine that they could put in that would make me buy the facelifted patrol is the td42, it's not crdi so i guess they wont bring it in but im still hoping.... i doubt if they would bring in the 4.8 6cylinder gas engine.
i use 130W Narva bulbs and Narva wiring harness and changed the bulb sockets to ceramic type. bought these sa shop ni GlennSter.Originally Posted by Boy Torotor
kelangan ko na ba linisan un maf sensor ko? 28K mileage na akin.. hehehe
pero pang cruising lang talaga.. sluggish nadin un akin dahil sa bigat ng mags. hehe!
boy torotot,
mag HID ka na :D
pm me ill give you a good deal.....
malaki ba improvement, approximately ilang percent increase ng brightness? how much approximately did the whole set cost(+ instalation) that time? any other good brands besides Narva(just in case walang available)? btw, i assume it doesn't matter if i have the same light sets as the new patrols, yong clear(don't know the term)...i still would need the bulb sockets changed to ceramic...right?
hehehe..would love to dude, pero even a good deal, i probably couldn't afford at this time. sobrang layo yata price ng HIDs sa conventional.
Boy Torotot, malaki ang improvement sa visibility. mas maliwanag ng at least 50%. mga around 1.5K ang nagastos ko around 2 yrs ago.
lens lang naman ang pinagkaiba ng new at old patrol. and kapag naglagay/palit ka ng wiring harness, kasama na dun yung new socket, plastic nga lang yung sa narva, kaya pinalitan ko ng ceramic type.
yup, finally had it changed sa Wizzard. big improvement. i got the wizzard-suggested osram all-weather, mas maganda raw ito compared to hella. seems okay naman yong osram. can't wait to drive in the rain at night to see how it performs.
P1,200 daw ang cleaning ng MAF sensor sa casa. Tanong ko sana kung may kasama ng fullbody massage yong owner from their receptionist...di ko na tinuloy baka ano pa gawin sa Patrol ko pag iniwan ko dun![]()
Now, if you can let me know where to get that contact cleaner spray(what brand is that?), and where is the MAF sensor and the step by step guide how to do it, then i'll be brave enough to try..![]()
maraming contact cleaners sa mga Ace Hardware, Handyman or DIY.
yung MAF sensor is located along the air inlet duct. if you open the hood, halos katabi ng right end of the radiator. meron wires connected dito. just unplug the wire and use a hex wrench to unscrew the MAF sensor (2 hex screws). spray contact cleaner dun sa parang electrode sa loob, then shake mo ng konti to remove excess contact cleaner solution. magdry na yan agad in a few seconds. then put it back. tapos.
Hmm... Masubukan din nga malinis ang MAF sensor ko.
By the way, does anyone know kung saan ok magpa refit ng weather linings maliban sa casa? Sira na kasi yung mga rubber linings dun sa rear doors ko, as in marupok and napupulbos na.
beefcake, ilang years na ba patrol mo? yung sa akin matagal ng sira pero hindi pa naman nagpupulbos. medyo butas butas na yung upper part. pero yung sa gilid ng doors, ok pa naman.
Boybi, '03 model yun. Bakit nga ba ganun yung rubber sa likod, ang daling masira? Yung mga doors sa gilid ok din yung sa akin.
thanks boybi. wil try it sa weekend.
speaking of rubber linings, mukhang madali lang naman i-DIY naman. yon nga lang, kelangan bumili ng linings. not sure kung meron sa banawe, otherwise sa casa talaga bibili.
wala bang planong EB ang mga troll owners dito ?
kung mayroon man, sali ako![]()