Results 521 to 530 of 1640
-
January 22nd, 2011 01:52 AM #521
Sir the boost controller is only use to regulate the boost with out it mag over boost ang turbo about 35 psi which is not safe for our stock turbo.
The reading and performance is all from the chip the boost controller does not put any additional hp or torque. Pang sakal lang siya nag boost.
The chip is a true performance chip it needs to be tap sa TPS wire and RPm wire nag ECU also the MAP sensor wire will be cut and connected to the chip. It is done that way to get the maximum performance. All plug and play chip is an analog design this chip need to be tuned according to the throttle position in every RPM.
-
January 22nd, 2011 09:45 AM #522
ahhh, so parang it controls every aspects para mag coordinate lahat to be put in a state of full potential... I hope I got it right...hehe
with regards naman dun sa boost controller, hehe yun pala yung function nun...kala ko something na nakakapag increase ng boost, its meant to limit pa pala hehe
matanong ko na din sir, for the benefit din nung mga gustong magpakabit para macompare nila..
ano naman ibig sabihin nung analog design for the plug and play sir?
saka ano yung TPs wire?Last edited by locoroco777; January 22nd, 2011 at 09:49 AM.
-
January 22nd, 2011 12:03 PM #523
Analog design Na plug and play are type of racing chip daw - as you know i already installed this chips to my truck and use it. Ito yung mga types na me tuning daw na d folder file and also it show some graph na nag tataas nag commonrail din. But if you will check in side i only have some diodes and others but not really a micro chip to save a access the setting you want.
TPS - Throttle Position System
Our truck have a safe mode when it comes to boost. With out altering the system it will not boost above 15 psi. That is the safe mode no other chip in the Philippines can prove na their boost goes above 15.
-
January 22nd, 2011 11:46 PM #524
Very impressive dyno result you have there, sir Dadz. Hoping that my truck will have similar result when it undergoes dyno graphing.
Latest mod that I made are DIY Boost Gauge housing and a base for the Smart Gauge:
Sanding the epoxy resin pieces
Applied primer
Finished with urethane paint
Applied double sided tape
Removed some panels to allow for a clean wiring installation
-
-
January 22nd, 2011 11:58 PM #526
Very nice workmanship sir galing mo talaga......................wish i have housing like that.
-
January 23rd, 2011 12:06 AM #527
-
January 23rd, 2011 12:18 PM #528
http://i20.photobucket.com/albums/b2...s/_DSC1046.jpg
sir GO1 di ka nahihirapan magdrive sa truck mo ang daming gadget sa harapan hehehe joke lang ang galing talaga wala na sigurong impassable sa truck moLast edited by tc327; January 23rd, 2011 at 12:20 PM.
-
January 24th, 2011 01:39 AM #529
-
January 24th, 2011 03:56 AM #530
Babala! Sarado at Ginagawa mga south bound flyovers along c5. Medyo mabagal Ang daloy kanina Ng...
Traffic!