Toyota Corolla 10th Generation Altis Owners [continued]

**burnik** · February 1st, 2016 11:43 AM

Originally Posted by 1D4LV

around 480-520k.

thank you sir

**rvm519** · February 1st, 2016 10:28 PM

Anyone who experience this?..rpm'drops when engaging clutch 1st gear usually and 2nd gear also.you have to put some'gas in order to get more rpm so that the body will not vibrate or the engine dies.clutch is still good coz acceleration is fast.the only prob is the rpm drops down when engaging usually in 1st gear n 2nd.i already clean the maf sensor and the throttle valve with the spray throttle cleaner.

**_Cathy_** · February 27th, 2016 09:58 PM

Nakaka sludge ba pag hindi masyado nagagamit yung auto? Once a week lang?

Sent from my GT-N7100 using Tapatalk

**vinj** · February 28th, 2016 11:06 AM

Is top end RPM still good or hirap yung engine to hit redline as well? If that happens, one possibility is the MAF is off-soec already. Re dropping RPM, perhaps an engine scan can help if you tried the possible culprit. I have the same problem on our 9th gen and the issue is the MAF which we have to replace.

Originally Posted by _Cathy_

Nakaka sludge ba pag hindi masyado nagagamit yung auto? Once a week lang?

Sent from my GT-N7100 using Tapatalk

As long as you get an service every year, and use a good oil and oil filter, should not be a problem. Make sure to drive the car hard once in a while too. Perhaps, akyat mo sa Skyway and drive it at 100-110kph on 3rd gear if conditions allow.

**timo07** · February 28th, 2016 03:12 PM

Hi vinj, won't a defective MAF Sensor light up the engine fault indicator on the dash? If not, how did the scan reveal this?

Sent from my SM-N9208 using Tapatalk

**vinj** · February 28th, 2016 07:08 PM

Originally Posted by timo07

Hi vinj, won't a defective MAF Sensor light up the engine fault indicator on the dash? If not, how did the scan reveal this?

Sent from my SM-N9208 using Tapatalk

In our case, the check engine only went on when I forgot to reconnect the MAF properly. The way I checked that I had a bad MAF before was by trying a MAF from a good engine.

**Leeborg** · February 29th, 2016 06:19 PM

Hi Guys,

Ok ba yung Tein H Tech sa Altis 10.5 Gen? From those who are experienced in lowering their rides.
I'm thinking if I should improve my handling and height. All stock suspension ko. Any other items
to consider to avoid mismatch sa lowering springs? Thanks!

**1D4LV** · February 29th, 2016 07:12 PM

Originally Posted by Leeborg

Hi Guys,

Ok ba yung Tein H Tech sa Altis 10.5 Gen? From those who are experienced in lowering their rides.
I'm thinking if I should improve my handling and height. All stock suspension ko. Any other items
to consider to avoid mismatch sa lowering springs? Thanks!

imho. mababa na ang stock height ng 10.5 ah. unless you have upgraded your rims.
if you would be putting lowering springs, make sure that your shocks are gas-types.

**Leeborg** · March 1st, 2016 11:08 AM

Originally Posted by 1D4LV

imho. mababa na ang stock height ng 10.5 ah. unless you have upgraded your rims.
if you would be putting lowering springs, make sure that your shocks are gas-types.

Salamat sa tips boss 1D4LV. Magpalit na lang ako siguro to 2015 altis rims. Di na ako mag springs.

**Treb927** · April 29th, 2016 09:21 PM

Originally Posted by rvm519

Anyone who experience this?..rpm'drops when engaging clutch 1st gear usually and 2nd gear also.you have to put some'gas in order to get more rpm so that the body will not vibrate or the engine dies.clutch is still good coz acceleration is fast.the only prob is the rpm drops down when engaging usually in 1st gear n 2nd.i already clean the maf sensor and the throttle valve with the spray throttle cleaner.

Mga sirs,

I have also have the same problem with my 2009 Altis, although i haven't clean the MAF sensor & throttle valve yet... any advise po? thanks in advance...