Results 21 to 29 of 29
-
Verified Tsikot Member
- Join Date
- Nov 2010
- Posts
- 28
-
July 24th, 2013 12:21 AM #22
When you had it "fix" instead of "remove and replace" failed parts.
It is neglect.
-
Tsikoteer
- Join Date
- Mar 2008
- Posts
- 52,731
July 24th, 2013 12:57 AM #23
-
August 1st, 2013 10:30 AM #24
Actually automotive technicians here are trained this way. To remove and replace.
Maybe you are fortunate to have a section that will calibrate, certify, and re certify parts.
How many mechanics have proper training in metrology?
You are very lucky you have access to proper instruments that you can repair a part
back to reliable use.
As for us out there, we remove and replace and that is it.
Surplus or oem, so long that it still works.Last edited by mark_t; August 1st, 2013 at 10:32 AM.
-
Tsikoteer
- Join Date
- Mar 2008
- Posts
- 52,731
August 2nd, 2013 01:06 AM #25nope, all we had was ordinary mechanics' tools. we tried to fix parts that we could, so we can use them again. you know... clean, solder or weld, un-bend, bend, adjust clearance, sandpaper, re-paint.. nothing major. no, we did not re-manufacture them. and we did it for two reasons: first, because it was challenging and fun; and two, we didn't have money to buy new parts. heh heh.
Last edited by dr. d; August 2nd, 2013 at 01:18 AM.
-
August 2nd, 2013 11:53 AM #26
just like dr. belo, fix, augment, cut, smoothen, reduce, repair. nothing much of replacement
-
Tsikoteer
- Join Date
- Jul 2013
- Posts
- 2,450
August 2nd, 2013 01:42 PM #27tanong lang, dapat ba mag-overheat ang makiina kung naka-rekta ang compressor (i.e. always engaged)?
dati kasi ganyan yung kotse ko pero hindi naman nag-overheat.
kaya sa palagay ko sa engine cooling system ang problema. hindi kaya isustain ang load ng aircon.
at sa pagkakaalam ko yung aux fan sa condenser mostly. may sariling fan ang radiator. kung sira ang aux fan, hindi lalamig yung hanging sa aircon.
-
August 2nd, 2013 01:53 PM #28
mawawala lang lamig ng air conditioning kung magooverheat. hindi magooverheat dahil nakareckta compressor. nagkataon lang siguro sa oto ng ts. maghigh pressure a/c kung overheat.
cooling system lang talaga problem.
-
August 2nd, 2013 10:15 PM #29
They replaced the water pump, so they finally found where the problem started.
I have seen this countless times, once at start up the pump breaking right in front of me,
Corroded water pumps which may be due
To that kwentong barbero, `only use water.` Nakaka sira daw ang coolant.Last edited by mark_t; August 2nd, 2013 at 10:21 PM.
Puwede i try, 1. Palit air filter 2. Linis throttle body 3. Linis MAF sensor 4. Check spark...
high idle RPM at engine start