1.0 Hi! I have stated my case clearly on this HHO project, it is a hobby and is under observation, no serious legal/technical/commercial implications yet. I have set objectives and standards to govern the undertaking. Those concern that I will be wasting my time, effort, and money in my undertaking, rest I assured that i will know the limits as well as when to give up, thank you. It is simple response to the initial post inquiring if anyone is in this HHO, and he would like to see it.

2.0 Since the subject on methyl alcohol (methanol) was brought out, allow me to show below the list of those I scanned earlier from resources before embarking into this HHO project on fuel economy. I do not recommend them here, and I leave it to the reader on how to go about them. They are as follows but not limited.

a) fix car - tune up/repair/tires/etc; b) driving habit; c) Plan trip; d) Acetone as additive; e) Acetone-boric acid as additive;f) xylene (xylol, currently used in fuel oils, can be found in hardware, the say); g) torco-TP7 as additive; h) popular Combo used by Americans AXG7 - acetone/xylene/torco combinations; i) ethyl alcohol - you are fully aware of this; j) methyl alcohol - deliberated by NASA and by a forum menmber; k) induction coii across power supply line; L) magnet around the fuel line;) special oil lubricants; m) various additives into fuel from big oil companies and private groups); signal sensor enhancer without the HHO; n) steam; 0) straight hydrogen input; m) HHO with enahncer, and many more out there.

I simply decided to work on the last item (m) for all the reasons I have, and a hobby. However, to those who are in business, if service is good and client satisfied, why not, it is mutual. Of course there are consideratiions in the selection from capital recovery, operation, maintenance, repair, ets, and continuing comsumables to be acquired in the market.

Something that strikes me in this undertaking, I developed a microtorch with about 1/2 in yellow flame and longer bluish flame after the yellow flame almost hard to see but burns paper at almost 2 1/2 inches away at 1/2 lpm HHO gas output (i do simple measurement method to obtain gas output). Also, I can pass my fingers slowly without feeling the heat, but cuts small steel wire when flame pointed at it directly, I am trynig to find the reason why this is so. Of course it is different when appied in minute quantity in the car , which I am all out to find. There are in the market for sale commercial hho welding/cutting torch and single/double cooking tops.


When my undertaking works, I will find the expert to explain in technical terms why it is working so others will have something at least to start with, if ever.