All New Isuzu MU-X // Alterra Next Generation

[aar0nix]

Sir baka may picture ka dyan ng pagkagawa mo ng plate, baka pwede makita.Salamat.

Di ko napicturan, pinakabit ko lang kasi sa kaibigan ko sa TeamICE. Ganito itsura...

[mhim101]

Di po ba mahirap gamitan ng remote control dahil nasa ilalim?


Sent from my iPhone using Tapatalk

ok lang gamitin
itutok mo ng lang yun remote sa baba
pag sa likod ka naupo yup medyo mahirap nga

[Grimm]

Uy nice. Hindi ko pala nabanggit dito. Naka EGR block na ako.

I used a single 3mm plate with 10mm hole in the middle, installed at the end of the egr pipe coming from the exhaust manifold. Di ginalaw yung egr mismo. I've had my egr blocked since 27k kms. 35k kms na ako. No check engine since installation.

What I noticed is earlier turbo spool, and of course nawala na yung smoke lalo pag matagal naka idle tapos floor ko at first gear. No change in power/torque.

I also monitored how the EGR operates via an obd scanner:

At Idle, it is fully open vs before where it is partially open at around 20-35% depends on the ambient temperature outside. Maybe because the small hole restricts the passage of exhaust air, thus the ecu thinks it needs to open up the egr to let more air in.

At partial throttle, it is fully closed, as compared to before that it is partially open unless engine load is 100%.

At full throttle, it is fully closed.

Overall happy with it 😎

Magkano po pakabit niyo sir aaron ng egr blocking?

[aar0nix]

Magkano po pakabit niyo sir aaron ng egr blocking?

Php 1k. May discount pag member ng TeamICE (Isuzu Car Enthusiast). 😎

[babybackrivs]

Php 1k. May discount pag member ng TeamICE (Isuzu Car Enthusiast). [emoji41]

Sir ano difference ng Team Ice and Team Isuzu Philippines?


Sent from my iPhone using Tapatalk

[ikloyputograpi]

Sir ano difference ng Team Ice and Team Isuzu Philippines?


Sent from my iPhone using Tapatalk

wala si sir aaron sa TIP un ang pinagkaiba, kidding aside
i'm not a member for both group officially, just a lurker like someone else

just a rough observation

TIP (circa 2011) , as they say they are a premiere organization, mostly EBs and car meets
but in general esp in mux page, mods mods mods... mostly hype, ngaun pansin ko k&n filter and the ic pipes
but can't blame 'em its basically for their satisfaction, and if there are queries, normally can be answered via reading manual.

then,

ICE (circa 2014), enthusiast, they know their vehicles well, there will always be a healthy discussion, do's and dont's, DIYs
if needed or query regarding parts, they will guide you where to get 'em, kala ko dati nga group of mechanics.

this is just my observation.. haha
please don't bash me

and a reminder for everyone..
stick lang po tayo questions related sa sasakyan

Sir pls dont flood this thread with questions not related to the car. Gawa po kayo ng bagong thread sa ibang section ng tsikot. Thanks

[ikloyputograpi]

Favor could someone measure our radiator fill neck diameter please, is it 32mm or 42mm?


Sent from my iPhone6s using Tapatalk

[bluberto]

Uy nice. Hindi ko pala nabanggit dito. Naka EGR block na ako.

I used a single 3mm plate with 10mm hole in the middle, installed at the end of the egr pipe coming from the exhaust manifold. Di ginalaw yung egr mismo. I've had my egr blocked since 27k kms. 35k kms na ako. No check engine since installation.

What I noticed is earlier turbo spool, and of course nawala na yung smoke lalo pag matagal naka idle tapos floor ko at first gear. No change in power/torque.

I also monitored how the EGR operates via an obd scanner:

At Idle, it is fully open vs before where it is partially open at around 20-35% depends on the ambient temperature outside. Maybe because the small hole restricts the passage of exhaust air, thus the ecu thinks it needs to open up the egr to let more air in.

At partial throttle, it is fully closed, as compared to before that it is partially open unless engine load is 100%.

At full throttle, it is fully closed.

Overall happy with it [emoji41]

Sir aaron, bakit mas pinili mo un blanking plates na ganyan than yung delete kit? Or totally block egr?


Sent from my iPad using Tapatalk

[Valentina2.0]

Is there any other way besides temperature matching to prevent windshield fogging sa MUX natin? It's dangerous talaga dahil it happens at night in my case


Sent from my iPhone using Tapatalk

Did you turn on the defogger button ?
There is a front windshield and rear windshield defogger. I use it when it rains, especially at night. Set the aircon temp to 24 or 25, and turn on defogger.

[Grimm]

Php 1k. May discount pag member ng TeamICE (Isuzu Car Enthusiast). 😎

Thanks sir.. Paano kaya maging member ng team ice?

[crosswind]

Sir ano difference ng Team Ice and Team Isuzu Philippines?


Sent from my iPhone using Tapatalk

TIP started here in Tsikot forums while Team Ice was founded by former members of TIP in 2014


Sent from my iPhone using Tapatalk

[aar0nix]

Favor could someone measure our radiator fill neck diameter please, is it 32mm or 42mm?

43mm bro

Sir aaron, bakit mas pinili mo un blanking plates na ganyan than yung delete kit? Or totally block egr?

Ganito kasi yung ginagawa nung nagkabit sa mga Crosswind. Added a 10mm hole to avoid Check Engine error. Lahat kasi ng nabasa ko sa Australian/Thai forums need may small hole para may madetect na hangin kahit papano yung egr. Pag wala kasing nadetect na hangin CEL error na.

Chose this over the electronic egr blanking because of reliability (less electronics) and price. 6-7k yata yung ANT MAF defender. I do river crossings, baka pag nabasa yun mag error. Limp mode sa gitna ng ilog. 😂

[MAXBUWAYA]

wala si sir aaron sa TIP un ang pinagkaiba, kidding aside
i'm not a member for both group officially, just a lurker like someone else

just a rough observation

TIP (circa 2011) , as they say they are a premiere organization, mostly EBs and car meets
but in general esp in mux page, mods mods mods... mostly hype, ngaun pansin ko k&n filter and the ic pipes
but can't blame 'em its basically for their satisfaction, and if there are queries, normally can be answered via reading manual.

then,

ICE (circa 2014), enthusiast, they know their vehicles well, there will always be a healthy discussion, do's and dont's, DIYs
if needed or query regarding parts, they will guide you where to get 'em, kala ko dati nga group of mechanics.

this is just my observation.. haha
please don't bash me

and a reminder for everyone..
stick lang po tayo questions related sa sasakyan

caR Clubs nowadays is all about getting sponsors

[Muvanza]

Guys delikado naman na i-asa natin lahat sa GPS ang mapping and navigation during travel. Best to do is to check where you will go first sa google maps. Then cross check with the car's gps kung same nga yung pupuntahan and route mo.

Ganyan yung nangyayari sa ibang bansa like sa US and UK, may mga instances na yung mga tao dinadala sa mga liblib na lugar or bangin.

Let's always remember that we are more intelligent than the gps navigation system. It's just a guide.

But if you feel adventurous, why not?

What I usually do though, I only use the map for tracking purposes. Para alam ko kung nasaan ako sa lugar na yun. Pag unfamiliar place, google maps muna talaga then cross reference sa gps navi ng mux.

Agree ako Sir, also guys pwede magsave ng napuntahan nanatin locations sa GPS ng HU at yung mismo location ng bahay natin. pwede ninyo siya ilagay sa favorites folder. Ganyan ginagawa namin para kung gusto namin puntahan ulit ung mga un iset lng namin sa destination route then kapag pabalik sa home location naman

[ikloyputograpi]

Salamat sa sukat ng rad fill neck diameter sir A. [emoji123][emoji4][emoji106]


Sent from my iPhone6s using Tapatalk

[bluberto]

43mm bro





Ganito kasi yung ginagawa nung nagkabit sa mga Crosswind. Added a 10mm hole to avoid Check Engine error. Lahat kasi ng nabasa ko sa Australian/Thai forums need may small hole para may madetect na hangin kahit papano yung egr. Pag wala kasing nadetect na hangin CEL error na.

Chose this over the electronic egr blanking because of reliability (less electronics) and price. 6-7k yata yung ANT MAF defender. I do river crossings, baka pag nabasa yun mag error. Limp mode sa gitna ng ilog. [emoji23]

Copy boss.. Thanks! Nagpatanggal na kasi ako hahaha
Okau naman po walang cel so far at hindi naman nagiba rpm or anything, and eala naman significant increase in torque/hp like what u said pero un napansin ko masmaganda response pag finloor un gas pedal. Di konalam kung related na din sa ic pipes haha


Sent from my iPhone using Tapatalk

[bluberto]

Thanks sir.. Paano kaya maging member ng team ice?

Turuan kita sir mag DIY using steel plate kahit di ka magpamember ng club hihihi [emoji38]


Sent from my iPhone using Tapatalk

[bluberto]

Sir baka may picture ka dyan ng pagkagawa mo ng plate, baka pwede makita.Salamat.

Sa Isuzu MUX Club Phils na group sa fb meron sir nagpost ng DIY and san nya nakuha, using scrap materials fr junk shop nagptulong sa latero, may pics din na after kung pano naipit sa egr pipe


Sent from my iPhone using Tapatalk

[budzkotse]

Question:

Ok po ba magpa service sa isuzu q.ave or edsa? Thanks

[ikloyputograpi]

Has anyone considered replacing their oem battery terminals?


Sent from my iPhone6s using Tapatalk