2008 Hyundai Starex (Gen. 4)

[Wh1stl3r2]

Thanks for the replies guys. Leaking window nasa rear right side. Wala naman kalawang sa may window. Forgot to mention may kalog sa steering when braking so I had the front end checked. Replaced all four dampers and inner, outer tie rods. May kalog pa rin.

Had the steering rack assembly replaced. Back to normal na yung GS. Pero at 47TKms I have to say medyo mahina talaga parts, specially since we baby this thing on rough roads. Good thing parts are cheap sa Fronte.

[jaggerx3]

Thanks for the replies guys. Leaking window nasa rear right side. Wala naman kalawang sa may window. Forgot to mention may kalog sa steering when braking so I had the front end checked. Replaced all four dampers and inner, outer tie rods. May kalog pa rin.

Had the steering rack assembly replaced. Back to normal na yung GS. Pero at 47TKms I have to say medyo mahina talaga parts, specially since we baby this thing on rough roads. Good thing parts are cheap sa Fronte.

Hit or miss talaga. Yung akin wala naman ganyan na problema. Problema ko lang ay ung power lock sa kanan na front door d nasabay

[gee_cruise]

Naku sir, that I do not know.

For reference, this is where the blanking plate was physically inserted. Kaya nga ang 10 minutes. Not sure where the GRX's is though.


ZIX888 also did a diagnostics check afterwards to determine if any error codes or CELs were triggered. None then, none since, so far. Have I redlined it, yes! Kakatuwa eh. But di naman madalas, at di ko pa nagagawa yung stress test ni CVT.

Mga boss, ano po material ginamit nyo to blank the EGR, does it need to be stainless plate or a normay GI sheet can do? TIA

[gee_cruise]

Naku sir, that I do not know.

For reference, this is where the blanking plate was physically inserted. Kaya nga ang 10 minutes. Not sure where the GRX's is though.


ZIX888 also did a diagnostics check afterwards to determine if any error codes or CELs were triggered. None then, none since, so far. Have I redlined it, yes! Kakatuwa eh. But di naman madalas, at di ko pa nagagawa yung stress test ni CVT.

Mga boss, ano po material ginamit nyo to blank the EGR, does it need to be stainless plate or a normal GI sheet can do? TIA

[weisshorn]

Stainless.

[spat]

Mga boss, pwede kong malaman ang mga cetane level ng mga diesel na ito:

Unioil
Caltex diesel
Total diesel
Shell fuelsave diesel
Shell nitRo diesel
Petron dieselmax
Petron turbo diesel

Ang alam ko dati unioil, petron turbo diesel at shell nitro diesel ay 55 cetane. Pero may nabasa ako somewhere na pag euro 4 daw ang krudo 55cetane na ata. Karamihan na ata ng gas station ngayon euro 4. Iniisip ko kung unioil pa din ako lagi magkakarga o kahit saan na sa nabanggit ko sa taas.
Thanks in advance.

[jaggerx3]

Mga boss, pwede kong malaman ang mga cetane level ng mga diesel na ito:

Unioil
Caltex diesel
Total diesel
Shell fuelsave diesel
Shell nitRo diesel
Petron dieselmax
Petron turbo diesel

Ang alam ko dati unioil, petron turbo diesel at shell nitro diesel ay 55 cetane. Pero may nabasa ako somewhere na pag euro 4 daw ang krudo 55cetane na ata. Karamihan na ata ng gas station ngayon euro 4. Iniisip ko kung unioil pa din ako lagi magkakarga o kahit saan na sa nabanggit ko sa taas.
Thanks in advance.

Nagamit ko yan lahat. Okay lahat yan maliban sa Unioil

[ronw123w124]

Nagamit ko yan lahat. Okay lahat yan maliban sa Unioil

Yung akin naman, maganda hatak pag Unioil ang gamit ko, pati gasolina ganun din as experienced on my Vios

[XTO]

Mga boss, pwede kong malaman ang mga cetane level ng mga diesel na ito:

Unioil
Caltex diesel
Total diesel
Shell fuelsave diesel
Shell nitRo diesel
Petron dieselmax
Petron turbo diesel

Ang alam ko dati unioil, petron turbo diesel at shell nitro diesel ay 55 cetane. Pero may nabasa ako somewhere na pag euro 4 daw ang krudo 55cetane na ata. Karamihan na ata ng gas station ngayon euro 4. Iniisip ko kung unioil pa din ako lagi magkakarga o kahit saan na sa nabanggit ko sa taas.
Thanks in advance.

The same lang halos. now that all are euro4's i have been with Shell.


Sent from my iPad using Tapatalk

[yebo]

Mga boss, ano po material ginamit nyo to blank the EGR, does it need to be stainless plate or a normal GI sheet can do? TIA

bili ka ng spatula, yung gamit ng mga painter panghagod ng masilya. yun magandang material pang blank ng egr.

[bobdetondo]

Thanks for the replies guys. Leaking window nasa rear right side. Wala naman kalawang sa may window. Forgot to mention may kalog sa steering when braking so I had the front end checked. Replaced all four dampers and inner, outer tie rods. May kalog pa rin.

Had the steering rack assembly replaced. Back to normal na yung GS. Pero at 47TKms I have to say medyo mahina talaga parts, specially since we baby this thing on rough roads. Good thing parts are cheap sa Fronte.

magandang hapon sir ,, ask ko lang sana magkano ang steering rack assembly ? salamat

[bobdetondo]

Mga boss, ano po material ginamit nyo to blank the EGR, does it need to be stainless plate or a normal GI sheet can do? TIA

sir tanong lang po,, meron ako GS HVX 09 po, pede rin ba blank EGR? ano ang magandang epekto nito? at meron din bang bad side? salamat,,

[yebo]

na-miss ng misis ko yung GS namin nung nagbyahe kami ng alaminos. miss nya yung space. di kasi siya makapagtaas ng paa sa dashboard ng everest hahaha!

kuha na lang daw ulit kami ng bago pag may all new starex na. hehehe!

[wsolo]

Thanks sir yebo for that insight, i guess the gs space once you get used to it gets sorely missed when going back to a vehicle with less space, btw already in the process of getting a 10s crdi mt this month, sayang lang di kasi pwede 2nd hand sa co, kinuha ko na sana yung old vgt unit nyo,

[skyflakes]

Comfortable talaga kasi ang starex..😀

[skyflakes]

Comfortable talaga kasi ang starex..😀
0
content://media/external/file/11878

[yebo]

sana yung next starex lagyan nila ng magandang noise insulation between the engine bay and cabin para di masyadong dinig ang engine noise. and better suspension bushings.

[Wh1stl3r2]

sana yung next starex lagyan nila ng magandang noise insulation between the engine bay and cabin para di masyadong dinig ang engine noise. and better suspension bushings.

Amen. While they're at it, sturdier sliding doors.

*bobdetondo
Di ko maalala, halungkatin ko receipt pag may time. Around 18-20K yata di pa kasama installation.

[ronw123w124]

magandang hapon sir ,, ask ko lang sana magkano ang steering rack assembly ? salamat

Friend ko naginquire lang kanina sa Seiring, 18k daw

[bobdetondo]

Amen. While they're at it, sturdier sliding doors.

*bobdetondo
Di ko maalala, halungkatin ko receipt pag may time. Around 18-20K yata di pa kasama installation.

salamat sir,,