2012 Ford Ranger

[SharkDines]

*taraki17a

Kaya pala lagi bumubusina, madaming beses ko po nagawa yung "Driver Configuration Mode".
Okay lang po kaya yun?

Hindi ko lang nagawa yung sunod na process Autolock by speed na 2x press.
Will do this later. Thanks a lot!

Hahaha galing magedit sir ah. xD

Haha. Sana ganyan sa totoong buhay.

[taraki17a]

*taraki17a

Kaya pala lagi bumubusina, madaming beses ko po nagawa yung "Driver Configuration Mode".
Okay lang po kaya yun?

Hindi ko lang nagawa yung sunod na process Autolock by speed na 2x press.
Will do this later. Thanks a lot!



Haha. Sana ganyan sa totoong buhay.

ok lang naman siguro, as long as the battery of the unit is healthy, i mean pwede macorrupt yung controller/computer kung hindi stable ang power while programming...

I also recommend disabling the Automatic unlocking for safety reason... Ang alam ko kasi, once na i-open nyo yung driver's door, pwede na buksan from the outside lahat ng doors, madali manakawan o masalisihan.

(No need na yata ng Driver config mode)
Automatic unlocking
Note: Automatic unlock is default enabled.
Press the button three time within three
seconds to toggle the automatic unlocking
function.
If the automatic unlocking function is
enabled:
30
Locks
• All doors will be unlocked while
opening the driver door or front
passenger door (vehicles not delivered
with remote control) from inside, with
the key in ignition.
If the automatic unlocking function is
disabled:
• Only the respective door will be
unlocked while opening from inside.
Note: Opening the rear doors will never
unlock the other doors, when opened from
inside.

[clairenceh]

Di pa rin ako magaling magmanual. MT owners, clutch lang ba gamit niyo pag reverse? ok lang ba yun? o nirerelease niyo clutch and gas na lang? mabilis na kasi clutch pa lang eh.

[SharkDines]

*taraki17a
Tama, hindi nga safe yung ganun lalo na kung sasakay ka or baba mas madali ka masilisihan ng mga masamang loob.

Di pa rin ako magaling magmanual. MT owners, clutch lang ba gamit niyo pag reverse? ok lang ba yun? o nirerelease niyo clutch and gas na lang? mabilis na kasi clutch pa lang eh.

Kung mabagal na reverse sa parking, Clutch+Brake at todo alalay ka lang sa Clutch dahil pag nabitawan mo aarangkada yun paatras.
Ganun po talaga pag manual, clutch lang reverse lalo na sa mga bago at malakas ang makina.

[zamoco_08]

Una, you need to enable "Driver configuration mode"

Driver configuration mode
Note: This operation has to be done within
30 seconds.
1. Ignition OFF to ON position.
2. Press central lock/unlock button 3
times.
3. Ignition ON to OFF position.
4. Press central lock/unlock button 3
times.
5. Ignition OFF to ON position.
The system will chirp to indicate that the
driver configuration mode is enabled.

Then, the auto lock by speed

Automatic locking by speed
Press the central lock/unlock button twice
within three seconds to toggle the
automatic locking by speed function. The
system will chirp when toggling

yung chirp is yung busina, bubusina yung sasakyan after every correct procedure done.

again, make sure naka lock lahat ng doors, may ilaw yung lock icon sa hu bago simulan procedure, ganyan kasi gumana sa akin.

Sir taraki ask ko lang po... for details your instructions...

1. Ignition OFF to ON position.( not need to start engine?)
2. Press central lock/unlock button 3
times.
3. Ignition ON to OFF position.
4. Press central lock/unlock button 3
times.
5. Ignition OFF to ON position.( not need to start engine?)

The system will chirp to indicate that the
driver configuration mode is enabled.

Then, the auto lock by speed
1. can I do this right after the above procedure?
2. Dapat ba naka start engine when doing the auto lock by speed?)

TIA :-)

[taraki17a]

i have just checked ford ph website, wala na 2.2 XLT A/T sa website, malamang hindi na nila offer?
just the 2.2 XLT M/T , 2.2 WT m/t, 2.2 WT a/t, and 3.2 WT a/t.

actually mas mataas pa ratio ng 1st gear kaysa sa Reverse... kung low speed maneuver like parking, clutch at brake nalang talaga kailangan mo, no need gumamit ng accelerator.

[taraki17a]

Sir taraki ask ko lang po... for details your instructions...

1. Ignition OFF to ON position.( not need to start engine?) NO need to start engine
2. Press central lock/unlock button 3
times.
3. Ignition ON to OFF position.
4. Press central lock/unlock button 3
times.
5. Ignition OFF to ON position.( not need to start engine?) NO need to start engine
The system will chirp to indicate that the
driver configuration mode is enabled.

Then, the auto lock by speed
1. can I do this right after the above procedure? YES, after the chirp confirming you that you have entered the driver config mode
2. Dapat ba naka start engine when doing the auto lock by speed?) NO need to start engine

TIA :-)

see above comments...

[nicenz]

Thanks guys. So hndi recommended ang auto lock?

Also meron na ba saatin dito pinas nag bebenta ng plasti dip?

[taraki17a]

Thanks guys. So hndi recommended ang auto lock?

Also meron na ba saatin dito pinas nag bebenta ng plasti dip?

tung auto UNlock sir ang hindi recommended... yung auto lock via speed sense is recommended

[clairenceh]

Swerte ng nakakuha ng XLT A/T. hahaha.