New and Used Car Talk Reviews Hot Cars Comparison Automotive Community

The Largest Car Forum in the Philippines

Page 1 of 2 12 LastLast
Results 1 to 10 of 19

Hybrid View

  1. Join Date
    May 2006
    Posts
    118
    #1
    fellow tsikoteers.My hilander has this issue everytime pag cold start. u have to press the gas pedal para magtuloy ang start, if not mamamatay engine. pag nagstart na sya ng mga 2mins ok na dahil i can run sa slex ng mga 120km/hr wd no problem . i already did several troubleshooting:

    idle is at 750-800rpm - so its not too low
    injection pump was overhauled at betan calibration just last month
    fuel filter was recently changed

    i was reading through several posts and it seems that 4ja1 have no glowplugs, yun lang naiisip ko cause ng hirap pag cold start. pero may nabasa rin ako na may isang glow plug daw sa may injection pump yung ibang direct injection engines na walang standard glow plugs.

    id appreciate some inputs from fellow tsikoteers and isuzu peeps.

  2. Join Date
    Jan 2006
    Posts
    1,682
    #2
    Sir, matagal ba na redondo bago magstart? How is the idle once it fires? Mileage po?

  3. Join Date
    May 2006
    Posts
    118
    #3
    Quote Originally Posted by 4JGtootsie View Post
    Sir, matagal ba na redondo bago magstart? How is the idle once it fires? Mileage po?
    sir one click lang start na, problem is pag nag start na idle nya is aangat ng mga 600rpm then bababa na until mamatay unless tapakan mo gas pedal. so ganun ginagawa ko mejo apak muna gas pedal ng mga 1 minute para uminit, after nun no problemo na. pag uminit na normal na idle nya at 750-800rpm. i've been doin some research and wala naman daw glow plugs ang hilander, so ano po nag tataas ng idle sa cold start? may temp sensor kaya sya? mileage is 91,000km.

  4. Join Date
    May 2007
    Posts
    53
    #4
    sir wer r u from? kung malapit k lng dito sa laguna pde kita mrecomend sa friend ko n tgaisuzu pr matignan yng sskyan mo.

  5. Join Date
    May 2006
    Posts
    118
    #5
    taga taguig po C5. pero nagwwrk ako dito sa alabang.taga saan sya sir?

  6. Join Date
    Jan 2006
    Posts
    1,682
    #6
    Quote Originally Posted by carlogt View Post
    sir one click lang start na, problem is pag nag start na idle nya is aangat ng mga 600rpm then bababa na until mamatay unless tapakan mo gas pedal. so ganun ginagawa ko mejo apak muna gas pedal ng mga 1 minute para uminit, after nun no problemo na. pag uminit na normal na idle nya at 750-800rpm. i've been doin some research and wala naman daw glow plugs ang hilander, so ano po nag tataas ng idle sa cold start? may temp sensor kaya sya? mileage is 91,000km.
    Its possible that its air in the lines. Check clamps, hose, filter housing and filter and its installation. Possible din na initial pumping of the injection pump is poor because of worn oil seal, but since bagong calibrate pa lang i assume that its new.
    Last edited by 4JGtootsie; January 27th, 2009 at 11:18 AM.

  7. Join Date
    May 2006
    Posts
    118
    #7
    Quote Originally Posted by 4JGtootsie View Post
    Let me do research on your engine then balitaan kita.
    4JGtootsie maraming salamat!!! mejo dead end na kse ko dito sa issue ko na to. tsk tsk

  8. Join Date
    May 2006
    Posts
    118
    #8
    Quote Originally Posted by 4JGtootsie View Post
    Its possible that its air in the lines. Check clamps, hose, filter housing and filter and its installation. Possible din na initial pumping of the injection pump is poor because of worn oil seal, but since bagong calibrate pa lang i assume that its new.
    seals are new dahil pinanood ko nung binuksan yung overhaul kit na may rubber seals at pinalit nila. napansin ko kaninang umaga na kahit na tatapakan ko yung gas pagkastart e after 1-2 seconds bababa rpm nya ng mga 200-250rpm then mag steady na dahil nakatapak ako sa pedal.

  9. Join Date
    May 2006
    Posts
    118
    #9
    Quote Originally Posted by 4JGtootsie View Post
    Its possible that its air in the lines. Check clamps, hose, filter housing and filter and its installation. Possible din na initial pumping of the injection pump is poor because of worn oil seal, but since bagong calibrate pa lang i assume that its new.
    di ko kasi alam ano nagcocontrol ng idle pag cold start since wala sya glow plugs. meron ba dapat linisin na idle up valve/controller? or temperature sensor ang 4ja1 na mkkdtct na malamig pa makina para taasan idle? how about yung throttle san ba yun lilinisin?

  10. Join Date
    Nov 2002
    Posts
    183
    #10
    May idle controller yan. Puwede mong taasan muna idle at start, then ibaba mo na lang after mag-init. Im also from taguig c5 and may repair manual ako ng 4jA1.

Page 1 of 2 12 LastLast
Isuzu 4ja1 - startup idle issue