Whining Noise

**tonyboy** · October 24th, 2016 04:03 PM

Hi Guys,

Just want to check what can cause a whining noise when my car is accelerating fron 1st to 2nd gear. Sounds similar when in reverse. No noise in neutral. Changed release bearing but noise is still present. Car is Honda City 2004 MT.

Thanks!

**rileykyrra** · October 24th, 2016 04:19 PM

Originally Posted by tonyboy

Hi Guys,

Just want to check what can cause a whining noise when my car is accelerating fron 1st to 2nd gear. Sounds similar when in reverse. No noise in neutral. Changed release bearing but noise is still present. Car is Honda City 2004 MT.

Thanks!

pressure plate sir nagpalit n po kayo?

**oj88** · October 24th, 2016 06:12 PM

It's unlikely clutch-related. When was the M/T fluid last replaced? What is its condition and level?

Changing the fluid, especially if it hasn't been replaced for a long time, should be the first thing to do. If the whine persists, it's very likely due to wear and tear. 1st and 2nd gear is the most used gears in a car that is frequently in stop and go traffic.

**tonyboy** · October 25th, 2016 09:31 AM

Originally Posted by oj88

It's unlikely clutch-related. When was the M/T fluid last replaced? What is its condition and level?

Changing the fluid, especially if it hasn't been replaced for a long time, should be the first thing to do. If the whine persists, it's very likely due to wear and tear. 1st and 2nd gear is the most used gears in a car that is frequently in stop and go traffic.

Replaced the transmission fluid 3 weeks ago prior to replacing the release bearing and clutch disc.

**oj88** · October 25th, 2016 09:45 AM

Originally Posted by tonyboy

Replaced the transmission fluid 3 weeks ago prior to replacing the release bearing and clutch disc.

Prior to the oil change, walang whining noise whatsoever? If so, are you sure that the correct gear oil viscosity was used? Is the gear oil level correct?

**miked** · October 25th, 2016 10:05 AM

1st and 2nd gears share the same synchronizer hub/sleeve.....

eto most likely ang may sira.....

chipped teeth on the synchro hub, worn synchro,........

bottomline, remove and disassemble the trans for better diagnosis.

**tonyboy** · October 25th, 2016 09:29 AM

Originally Posted by rileykyrra

pressure plate sir nagpalit n po kayo?

Release bearing and clutch disc pa lang sir

**dr. d** · October 24th, 2016 06:23 PM

Originally Posted by tonyboy

Hi Guys,

Just want to check what can cause a whining noise when my car is accelerating fron 1st to 2nd gear. Sounds similar when in reverse. No noise in neutral. Changed release bearing but noise is still present. Car is Honda City 2004 MT.

Thanks!

baka ang differential gear?