PLDT Fibr

[attyallanlatras]

I believe your old LAN network configuration isnt communicating with your new LAN because the old LAN has no connection yet with your new LAN

You can run an ethernet cable from your old LAN port to your new LAN port or you can configure your linksys router to act as bridge that connects to your new PLDT fiber router

I believe the cignal digital box is designed to run in any ethernet port because all LAN ports are the same in an ethernet topology. LAN port offers the faster speed of connection compared to wifi a/b/g standards and its more stable compared to wifi (radio) signal which is suceptible to signal fading

For best ethernet experience you need an ethernet with 2.5Gbps speed because its the latest standard..check your manual for the ethernet speed of your fiber router

For best wifi experience you need wifi6 capable routers..again check the manual of the fiber wifi router

Sent from my SM-G532G using Tapatalk

Sorry sir if I gave you the wrong impression that already have the Fibr Plus set-up with 50mbps (with 3 mesh and cignal tv), what I meant was I applied and was approved (since 50mbps na yung speed ko from formerly 25mbps only) but the 3 mesh and the cignal tv digi box has not yet been delivered (7 to 10 days and lead time). I have rolled out 2 years ago cat6 cables around my house and connected 2 gigabit switch hubs with my Linksys 1900 as my main router. One gigabit switch hub is near my Led TV as well as my Nvidia Shield and both my TV and the Nvidia Shield are connected through LAN and have good internet connection (30 to 40mbps). Now, my concern is if the PLDT tech guy comes with the cignal digi box for installation, can he just connect a LAN cable on Lan 4 of the PLDT Fibr router to my Linksys router and then my gigabit switch hub to the Cignal Tv Digi Box. Sorry noob here....