2010 Mitsubishi ASX Crossover

[Noel Salisipan]

Wag naman sana manipis. Wala pa nga ako 3k.

Although one thing I notice when I wash my car sa bahay, yung breaks is making some noise na di maganda. Parang metal to metal sound. Yung garage ko kasi medyo sloping down to the street so kailangan ko mag breaks pag palabas ako. I was thinking na baka kasi nabasa lang yung disc. After a while nawawala na e.

Sama ko na rin yun pag nag pa 5k PMS ako.

10k pa naman linis ng mga brakes.

Pero nakaka-alarma na nga yan lalo kung may tunog na.

So, posible rin na manipis na siya dahil madalas mong gamitin. Dahil nung nakita ko yung pad sa drum brake ay manipis at maliit lang siya.

Goodluck bro, at congrats sa ASX mo, bago pa talaga.

[Noel Salisipan]

Im not after for the premium... just the cheapest 95 octane (XCS/Gold)...

Hindi ba "Premium" na ito, 95RON?

Blaze & V-power ay super premium.

Silver/fuel save/93RON is unleaded.

Regular & 90/91RON. Is the cheapest?
(querry lang, para kasing confusing.)

[cta2]

:-) I meant any high end gas like v- power or blaze... Which are higher than 95... I just use any cheaper gas that's at least 95... Normally petron xcs / caltex gold... I don't go any lower than these if possible.

[ghosthunter]

:-) I meant any high end gas like v- power or blaze... Which are higher than 95... I just use any cheaper gas that's at least 95... Normally petron xcs / caltex gold... I don't go any lower than these if possible.

My ASX runs fine on 93 octane gasoline. (Caltex silver or equivalent in other brands).

[Noel Salisipan]

:-) I meant any high end gas like v- power or blaze... Which are higher than 95... I just use any cheaper gas that's at least 95... Normally petron xcs / caltex gold... I don't go any lower than these if possible.

Ok bro.

Before, ti-nry ko rin ang 93RON ay wala naman akong diprensyang naramdaman sa power & FC. Pero dahil 50-cents lang difference ng 93 vs RON e nag-stick na ko sa 95RON. Mas kampante pa ako kasi premium siya.

Unless magkaroon uli ng promo ang fuel save na free liters in every full tank.

Tanong lang, hindi naman kaya malito ang ECU o ICE sa pagbabago ng RON sa changes ng fuel?

[Noel Salisipan]

Hello just some quick questions and observations from my ASX

1. Where is our ASX made? Thailand or Japan or somewhere else?...Just curious :-)

2. Im still doing good with the mileage... 7.5-8Km/L using 95 octane (XCS/Gold) all city driving... I did try using 93 octane, my mileage dropped to 7Km/L... but no noticeable difference in power.

3. Im done with my 5K check up (I follow the 5K instead of 10K due, cant reach 10K in 6 months)... call it psychological, but I feel the car is faster!

1. Japan made ang ASX bro.
2. Mas apektado ang FC sa driving habit, trafic at short distance run.
(pero pag out of town at kahit full load ay nakakakuha ako ng 13kpl sa FC)
3. Kahit synthetic oil gamit natin bro e 5k talaga ang PMS dahil sa oil filter na pinapalitan.

Lastly, maganda at kampante ako sa speed o performance ng ASX.
Except na lang kung sanay ang isang driver sa 6cylinder na kotse, or higher.

[larry0609]

1. Japan made ang ASX bro.
2. Mas apektado ang FC sa driving habit, trafic at short distance run.
(pero pag out of town at kahit full load ay nakakakuha ako ng 13kpl sa FC)
3. Kahit synthetic oil gamit natin bro e 5k talaga ang PMS dahil sa oil filter na pinapalitan.

Lastly, maganda at kampante ako sa speed o performance ng ASX.
Except na lang kung sanay ang isang driver sa 6cylinder na kotse, or higher.

Every 5k ba ang PM ng car mo, Noel? I'm just wondering why because mine is every 10k as advised at the casa where i'm having it serviced.

[Noel Salisipan]

Every 5k ba ang PM ng car mo, Noel? I'm just wondering why because mine is every 10k as advised at the casa where i'm having it serviced.

Ganun na nga Bro Larry, sa Dagupan ako nagpapa-PMS.

Syn. oil gamit ko pero kailangan bumalik nitong 15k Km para change ng oil filter.

Ganun din nangyari nung 5k Km ko, bumalik din ako para sa change ng oil filter.

Tanong ko lang kung bakit nag-oofer ng 10k Km na syn. oil pero wala bang pang "10k Km na oil filter"?

[larry0609]

Wag naman sana manipis. Wala pa nga ako 3k.

Hindi ko pa naman nakakalimutan tanggalin ang hand break pag andar ko (hehehe :D).

Although one thing I notice when I wash my car sa bahay, yung breaks is making some noise na di maganda. Parang metal to metal sound. Yung garage ko kasi medyo sloping down to the street so kailangan ko mag breaks pag palabas ako. I was thinking na baka kasi nabasa lang yung disc. After a while nawawala na e.

Sama ko na rin yun pag nag pa 5k PMS ako.

Normal lang na meron squeking sound pag nag wash ka ng car mo lalo na, say, nag car wash ka today then bukas mo pa gagamitin, parang nag stick lang ng konti pad ng either hand break or yun main brakes ng car dahil nga nabasa at natuyo. After just a second mawawala na yan sound. Also, if you will notice, after nag wash ka ng car in just a few hours parang meron rust sa brake disc and that's because of oxidation. That is also one cause of sound eminating from the brakes when you first drive it after a car wash.

[larry0609]

Ganun na nga Bro Larry, sa Dagupan ako nagpapa-PMS.

Syn. oil gamit ko pero kailangan bumalik nitong 15k Km para change ng oil filter.

Ganun din nangyari nung 5k Km ko, bumalik din ako para sa change ng oil filter.

Tanong ko lang kung bakit nag-oofer ng 10k Km na syn. oil pero wala bang pang "10k Km na oil filter"?

No idea bro. But my car's oil filter is being changed the same time as the oil change happens. If you are using synthetic oil, which i am also using, the PM schedule should always be every 10k, after the 1k PM. The oil filter is still good even after 10k as what my service technician showed to me during my last 20k PM. This is also true with other car brand because I used to own a Toyota RAV4 and a CRV and this is the same PM frequency that is being followed. But if you are not using non synthetic or mineral based oil, then the casa will requier you to have a 5k frequency PM sched.

[Noel Salisipan]

No idea bro. But my car's oil filter is being changed the same time as the oil change happens. If you are using synthetic oil, which i am also using, the PM schedule should always be every 10k, after the 1k PM. The oil filter is still good even after 10k as what my service technician showed to me during my last 20k PM. This is also true with other car brand because I used to own a Toyota RAV4 and a CRV and this is the same PM frequency that is being followed. But if you are not using non synthetic or mineral based oil, then the casa will requier you to have a 5k frequency PM sched.

I will clarify this to Casa. Yun nga rin ang alam ko kaya lang di na ko nagbusisi nung 5k ko kung bakit ganun.

Thanks for the heads-up Bro Larry!

BTW, san ka pala huling nagpa-PMS, anong dealer din yun, kung may contact # ka nila e hingin ko na rin.

Thanks.

[larry0609]

I will clarify this to Casa. Yun nga rin ang alam ko kaya lang di na ko nagbusisi nung 5k ko kung bakit ganun.

Thanks for the heads-up Bro Larry!

BTW, san ka pala huling nagpa-PMS, anong dealer din yun, kung may contact # ka nila e hingin ko na rin.

Thanks.

I always have my car's PM done at Diamond Motors in Marcos Highway, Cainta. Don't have their number but you can easily get it from the internet as they have their own website.

[Noel Salisipan]

I always have my car's PM done at Diamond Motors in Marcos Highway, Cainta. Don't have their number but you can easily get it from the internet as they have their own website.

Thanks Larry.

I can tell them (Motorplaza-Dagupan) about Diamond motors PMS.

[Bi2212]

Finally got our red asx yesterday. What gasoline do you suggest? First time car owner right here.

[ghosthunter]

Finally got our red asx yesterday. What gasoline do you suggest? First time car owner right here.

Any gasoline would do just fine in the ASX. I have used 93 octane without problems.

[sole_gemini]

Hi guys. May nagpapintura nb ng stock rims dito?

[dg1110]

Hi guys. May nagpapintura nb ng stock rims dito?

Was planning to paint it black or gun metal sana... Gayahin ko kasi yung sa ASX Black pero nag end up napabili na lang ako ng new rims. Hehehe.

[Noel Salisipan]

Was planning to paint it black or gun metal sana... Gayahin ko kasi yung sa ASX Black pero nag end up napabili na lang ako ng new rims. Hehehe.

Plano ko rin yan bro.
Pero nung ina-analyze ko na sya, tingin ko mabusisi.

Para mas maayos ang pagpintura, mas maganda kung ihihiwalay ang rubber sa mag. Then possible na wheel balansing pag ibabalik.

Kung maayos man ang pintura ay swerte kung abutin ng isang taon na ganun pa rin kaganda yung repaint. So,, ulit na naman ang proseso.

Finally, sulitin ko muna yung stock at later ko na lang mag-upgrade ng mga gulong. Since mahirap ding hanapin hanggang ngayon yung stock na gulong.

[ghosthunter]

Plano ko rin yan bro.
Pero nung ina-analyze ko na sya, tingin ko mabusisi.

Para mas maayos ang pagpintura, mas maganda kung ihihiwalay ang rubber sa mag. Then possible na wheel balansing pag ibabalik.

Kung maayos man ang pintura ay swerte kung abutin ng isang taon na ganun pa rin kaganda yung repaint. So,, ulit na naman ang proseso.

Finally, sulitin ko muna yung stock at later ko na lang mag-upgrade ng mga gulong. Since mahirap ding hanapin hanggang ngayon yung stock na gulong.

For best durability, you will need to have the wheels powder coated. I was planning to have my wheels powder coated to a dark grey or gun-metal color finish. But I got lazy and simply used the GTA wheels as-is. I might still have the wheels powder coated but not in the immediate future.

[Noel Salisipan]

For best durability, you will need to have the wheels powder coated. I was planning to have my wheels powder coated to a dark grey or gun-metal color finish. But I got lazy and simply used the GTA wheels as-is. I might still have the wheels powder coated but not in the immediate future.

Thanks for the suggestion sir GH.
Me too, not in the immediate future. Susulitin ko muna yung stock na gulong at mags.