All New 2017 Mazda 3

[jojopad]

Hello! Anyone here knows where I can buy a wire insulation cover like this one used for the Mazda Skyactiv?

[ninjababez]

Hello! Anyone here knows where I can buy a wire insulation cover like this one used for the Mazda Skyactiv?

try mo shrink tubes bro, multilayer mo nalang then yun pvc insulator or fibreglass sleeves for additional protection
tapos i-sleeves mo narin yun iba para uniform

[jojopad]

try mo shrink tubes bro, multilayer mo nalang then yun pvc insulator or fibreglass sleeves for additional protection
tapos i-sleeves mo narin yun iba para uniform

Thanks! I'll look for these at the hardware store.

Here's the reaaon why I'm looking for this insulator. I found out just after my car's PMS last Dec that one of the spark plug wires are exposed. I'm not sure if this is fine so I'm thinking of installing a wire insulator just for peace of mind

[yapoy86]

Thanks! I'll look for these at the hardware store.

Here's the reaaon why I'm looking for this insulator. I found out just after my car's PMS last Dec that one of the spark plug wires are exposed. I'm not sure if this is fine so I'm thinking of installing a wire insulator just for peace of mind

no issue naman yan sir.. you can wrap it with electrical tape. if you're worried, those are not high tension wires.. since the ignition coil is directly sitting above the spark plug

[ninjababez]

if na-OC ka lang bro pwede ito nalang, readily available sa auto supplies, tapos pili ka yun smallest na kakasya
lagyan mo all four parin para uniform

[jojopad]

Stick na lang ako sa shrink tubes para sure na walang kakalog sa engine bay [emoji12]

[papi smith]

Eto bro, nadaanan ko lang sa lazada when I was looking for garage hooks, then naalala kita

Sent from my Mi A1 using Tsikot Forums mobile app

[thearsenal1205]

Eto bro, nadaanan ko lang sa lazada when I was looking for garage hooks, then naalala kita

Sent from my Mi A1 using Tsikot Forums mobile app

mas maganda itong shrink tubes than the usual electrical tape.

[_Edward_]

Hi guys. Been following this thread for quite some time already but just created an account now to make this post. Would like to seek for your advice if all the items below are necessary for 70k PMS (actual mileage:46k). TIA for your inputs.

[travajante]

Hi guys. Been following this thread for quite some time already but just created an account now to make this post. Would like to seek for your advice if all the items below are necessary for 70k PMS (actual mileage:46k). TIA for your inputs.

Just go for oil change & brake cleaning. Bring your own brake cleaner. Have them rotate your tires front-back every oil change. Forget the rest.[emoji4]
You can DIY inspect/replace your own intake & cabin filters.

Sent from my SM-G970F using Tapatalk

[jojopad]

Nakita ko sa Castrol official store sa shopee 2,349 php 4 liters plus may 1 liter free. Not bad for the price.

Now contemplating if mag Castrol magnatec ba ako, Amsoil OE or Amsoil SS this November oil change hahaha. 6 months pa din plan ko na OCI.

Sent from my SM-G980F using Tsikot Forums mobile app

How about this one?

[_Edward_]

Just go for oil change & brake cleaning. Bring your own brake cleaner. Have them rotate your tires front-back every oil change. Forget the rest.[emoji4]
You can DIY inspect/replace your own intake & cabin filters.

Sent from my SM-G970F using Tapatalk

Thank you sir. Appreciate your inputs!

[gauss]

Hello again fellow 2017/2018 owners.

It's going to be my first PMS outside of the Yojin 3. Any recommended shops in or around Paranaque/BGC/Muntinlupa areas? Or is it better to continue with casa? (I went to Mazda Greenhills previously)

I've had zero headaches in my first 3 years of ownership and would like to keep it that way

[travajante]

Hello again fellow 2017/2018 owners.

It's going to be my first PMS outside of the Yojin 3. Any recommended shops in or around Paranaque/BGC/Muntinlupa areas? Or is it better to continue with casa? (I went to Mazda Greenhills previously)

I've had zero headaches in my first 3 years of ownership and would like to keep it that way

Wherever you go, make sure to use only Genuine Mazda Skyactiv-specific oil filter(designed WITHOUT AntiDrainBackValve, unlike most aftermarket ones) & ACEA A5/B5 5w-30 Full Synthetic Oil.

Sent from my SM-G970F using Tapatalk

[_Edward_]

Hi guys, thinking of changing my tires - 205/60/16 (Bridgestone Turanza). Is it okay if I use to 205/65/16 (Michelin Primary 4ST)? What are the pros & cons? Or do you have any suggestions on better tire brands/models/size, specifically with regard to quiet ride and comfort? Appreciate your inputs. Thank you.

Sent from my SM-G975F using Tapatalk

[nirvblakr]

Hi! I don’t know if this was asked already but I am planning to have my Mazda 3 PMS serviced out of CASA.
Is there a way to turn off the “wrench” icon in the dashboard permanently?

[Archerfish]

Hi! I don’t know if this was asked already but I am planning to have my Mazda 3 PMS serviced out of CASA.
Is there a way to turn off the “wrench” icon in the dashboard permanently?

I think you just need to reset it.

Let me post where I bought my filters:

https://shopee.ph/thunder_acdelco?smtt=0.0.9

[JohnM]

Hi! I don’t know if this was asked already but I am planning to have my Mazda 3 PMS serviced out of CASA.
Is there a way to turn off the “wrench” icon in the dashboard permanently?

IIRC under the Maintenance menu just change some of the values and it will disappear.

[Archerfish]

IIRC under the Maintenance menu just change some of the values and it will disappear.

That's right, but you need to do something else after that. You press and hold the "illuminating switch" then turn on the car, without starting it. There's a warning sign that will blink, then the reset is done.

His question is to turn it off permanently, and I don't know if that's possible.

[JohnM]

That's right, but you need to do something else after that. You press and hold the "illuminating switch" then turn on the car, without starting it. There's a warning sign that will blink, then the reset is done.

His question is to turn it off permanently, and I don't know if that's possible.

It's possible. No wrench appeared after I changed those settings and I didn't have to do a reset. That was 5 years ago.

I'll check the car later.