NLEX EC Tag Concerns

[17Sphynx17]

So note pala yun sa RFID ng Easy Trip.

Bawal SINGKIT
Bawal NAKATINDIG

=)

[ninjababez]

So note pala yun sa RFID ng Easy Trip.

Bawal SINGKIT
Bawal NAKATINDIG

=)

may nakikita akong L300 delivery van and canter may easytrip rfid sticker sa windshield. nakita ko rin sa parang poster nila na may sample location ng sticker sa windshield nakalagay.

Sent from my Redmi Note 9 Pro using Tapatalk

[dr. d]

it would be nice to know,
where is the tollgate sensor located?

[n0cary3t]

normally sensor nasa taas. parang solar panel.


Sent from my iPhone using Tapatalk

[yapoy86]

First time ko narinig na may specific kotse/brand ng kotse na kahit sa headlight di gagana EasyTrip.

May ibang mazda owners ba that can confirm? Kasi tingin ko, tamad lang ayusin yung dikit nung taga Easytrip na pinuntahan dun at kung anu anu na lang sinabi, or sinabing sabihin.

Unless may something unique sa Mazda headlight, may duda ako.

May nasabi ata dati about RFID stickers na bawal on vertical surfaces. So yung mga walang tint na windshield pero vertical yung windshield alala ko bawal dikitan dahil di mascan maayos din (unless im misremembering it).

sa mazda 3 ko hirap ma read yung rfid.. masyado daw vertical yung headlight

[tigerdoods]

My autosweep rfid with easytrip merged always works on my mazda 3 in newer tolls like Calaex (easytrip) but always fail in Cavitex (easytrip). The rfid installed on the drivers headlight.


Sent from my iPhone using Tapatalk

[dr. d]

normally sensor nasa taas. parang solar panel.


Sent from my iPhone using Tapatalk

in that case,
i suppose the most logical place to paste one's tag would be at the windshield.
that may also explain why tags placed on much lower, too-vertical headlight surfaces, won't always be read by the sensor.

[yebo]

So if it is located at near the center upper part of the windshield (like the LTO sticker) it will work? Yun kasi installation guide nila says to install on the right lower part. I don't like to install it there since 1, mahirap mag-cut ng tint sa location na yun; 2, it is near the GPS antenna; and 3, it will be in the way of sight, nakakailang. Until now di ko pa nainstall kasi dami ko nababasa na hindi nagwowork. Buti pa yung easytrip pag hindi mabasa sa loob i-open mo window tapos ikaway mo sa taas sure na magwork.

[dr. d]

...all this, because the front windshield is tinted?
the solution seems easy enough...
heh heh.

[kapitan88]

same with mine, lahat ng bulok na gamit nila nasa cavitex. My autosweep RFID linked to easytrip account have about 6/10 hit sa coastal/cavitex, pero never had a problem sa slex/nlex/harbor link/calax. Pansin ko yung mga gates ng EasyDrive na ginawa early this year ang mga problematic gates, kaya lagi ako dun sa oldest 3 rfid gates pila; pero today, i tried yung new RFID dedicated gate, ng northbound, na dating RFID/Cash, worked flawlessly. sana i upgrade na nila all the other gates.

My autosweep rfid with easytrip merged always works on my mazda 3 in newer tolls like Calaex (easytrip) but always fail in Cavitex (easytrip). The rfid installed on the drivers headlight.


Sent from my iPhone using Tapatalk

[yebo]

...all this, because the front windshield is tinted?
the solution seems easy enough...
heh heh.

As i said doc, i will be cutting a window on the tint just like the LTO rfid. Yun lang kasing mga headlight installed rfid and nagbibigay ng doubts sa akin kasi nasa labas na yun di pa din madetect. Tapos meron pa yan sa mazda na kahit walang tint hindi madetect. So i am thinking may problema din kung saan sa windshield ilalagay - left, right, center, up, down.

[jigeloh]

May lalabas daw na next Gen RFID nung nadalaw ako sa NLEX San Fernando office nila. Pina fillup ako sa logbook, kapag dumating they will notify asap.


Sent from my iPhone using Tapatalk

[gongrhey]

They have it in Shell C5 near the SLEX entry (past Heritage). 200 minimum load required to get an EasyTrip RFID sticker.


Sent from my iPhone using Tapatalk

Clarify ko lang bro available dito sa Shell C5 ang pag link ng easytrip to existing autosweep?

[yapoy86]

As i said doc, i will be cutting a window on the tint just like the LTO rfid. Yun lang kasing mga headlight installed rfid and nagbibigay ng doubts sa akin kasi nasa labas na yun di pa din madetect. Tapos meron pa yan sa mazda na kahit walang tint hindi madetect. So i am thinking may problema din kung saan sa windshield ilalagay - left, right, center, up, down.

basta big enough yung headlight at naka tilt say 30 degrees madaling ma read..

yung sa mitsu adventure ko walang mintis kahit saan ako lane dumaan.. nasa headlight din yun..

pag autosweep rfid sa gitna nilalagay, sa likod ng rear view mirror, yung easy trip sa lower right corner naglalagay

pag naka tint, sabi nung taga install, basta 3M na black walang issue, pero yung ibang brands daw not sure sya kasi minsan hindi daw ma detect

[Egan101]

Clarify ko lang bro available dito sa Shell C5 ang pag link ng easytrip to existing autosweep?

Not sure bro but they do give out EasyTrip RFID stickers. I want separate RFID tags for Autosweep and EasyTrip.

I did that before - using my Autosweep RFID to get an EasyTrip account. When the RFID sticker was damaged, I had to do both all over again. What I did with my FXT was separate tags. I will entertain using only one tag if the time comes that EasyTrip and Autosweep gets integrated into just a single account and load is useable on both systems.


Sent from my iPhone using Tapatalk

[yapoy86]

Not sure bro but they do give out EasyTrip RFID stickers. I want separate RFID tags for Autosweep and EasyTrip.

I did that before - using my Autosweep RFID to get an EasyTrip account. When the RFID sticker was damaged, I had to do both all over again. What I did with my FXT was separate tags. I will entertain using only one tag if the time comes that EasyTrip and Autosweep gets integrated into just a single account and load is useable on both systems.


Sent from my iPhone using Tapatalk

nung una gusto ko din sana integrated, yun pala need mo din ng separate accounts.. wala din silbi.. much better to have both na lang para iwas hassle.. tsaka sure ka na mababasa ng tama..

[gongrhey]

Not sure bro but they do give out EasyTrip RFID stickers. I want separate RFID tags for Autosweep and EasyTrip.

I did that before - using my Autosweep RFID to get an EasyTrip account. When the RFID sticker was damaged, I had to do both all over again. What I did with my FXT was separate tags. I will entertain using only one tag if the time comes that EasyTrip and Autosweep gets integrated into just a single account and load is useable on both systems.


Sent from my iPhone using Tapatalk

Ok bro copy thanks sa input.

[yebo]

nung una gusto ko din sana integrated, yun pala need mo din ng separate accounts.. wala din silbi.. much better to have both na lang para iwas hassle.. tsaka sure ka na mababasa ng tama..

Did i understand this correctly? Even with an integrated rfid (nlex OR slex) one needs to oay for 2 accounts? 1 account for paying at nlex and another account for paying at slex?

[17Sphynx17]

Did i understand this correctly? Even with an integrated rfid (nlex OR slex) one needs to oay for 2 accounts? 1 account for paying at nlex and another account for paying at slex?

YEP. That's why i never understood why it is being favored by some when you still have to maintain 2 accounts.

Having 2 stickers is the easier way to go since you are in and out of the installation office, rather than integration.

If 1 sticker gets damaged, you deal with issues on 1 account. If you damage the integrated sticker account, you have to deal with 2 accounts and hassle of the "reintegration' and most likely transfer of funds from the old accounts.

On another note, for Autosweep (assuming you have multiple cars/accounts) you can easily apply for creating a single account for all vehicles by submitting your docs to their office as they have a form you can download from the webiste.

For EasyTrip, that form doesn't exist online. So you have to request to them via email. Their Twitter account also doesnt reply to tags and you can't DM. So I don't like Easytrip's "customer service" as they seem ill prepared with a lot of things. No standard forms for what should be obvious things. They can easily check Autosweep standard forms and create their own equivalents yet they don't. So sad...

[Egan101]

Did i understand this correctly? Even with an integrated rfid (nlex OR slex) one needs to oay for 2 accounts? 1 account for paying at nlex and another account for paying at slex?

Korek! One account for Autosweep, another account for EasyTrip. I use Autosweep regularly as I am from Paranaque and I use SLEX going to the office in BGC.

I only load my EasyTrip account when I need to go to Pampanga.


Sent from my iPhone using Tapatalk