audio set-up for beginners [continued]

[markygy]

4 channels po. Ch 1 and 2 naka bridge for the sub . 3 and 4 sa front speaker. Na pag alaman ko po na distorted lang is yung ch 3

Uhhm boss, when connecting a 4 channel amp to a pair of front speakers, make sure to connect the speakers wires to channels 1 & 2 of the 4 channels amp. This is because in general the front signals of a 4 channel amp is located on channels 1 & 2, while the rear signal is on channels 3 & 4. Para lang po tama ang install ninyo.

Ang tanong ngayon is where did you set the filters of the amplifier on channels 1&2 and 3&4?