"Tamang OC lang" - a newbie's guide to car appearance maintenance

[monty_GTV]

yeah, try mo lang until makuha mo tamang consistency. consider not only the foaming but yung lubricity, kahit hindi masyado thick ang frothing if the lubricity is good, pwede na. but its nice to look at nga lang if makapal yung bula[emoji38]

Sent from my SM-G960F using Tapatalk

[zechs]

First rinse (just water only) after p&s bead maker application about a week ago. Looks good.

[zechs]

I think I may have finally figured out the dilution. Haha. 1.5oz then around 300ml water. See the foam cannon below. Ganun lang gamit ko. Thick enough foam to drag down the contaminants off the paint.

[gls2001]

I think I may have finally figured out the dilution. Haha. 1.5oz then around 300ml water. See the foam cannon below. Ganun lang gamit ko. Thick enough foam to drag down the contaminants off the paint.

I get the same foaming using 100mL soap and foam gun filled with water till 1000mL mark. Using Meguiar’s Ultimate Wash and Wax soap.




Sent from my iPhone using Tapatalk Pro

[zechs]

Magastos noh pag 100ml soap? Haha sa isang gallon parang ilang washes lang. Although ang pwede gawin kung 100ml soap then 1000ml water is ung natira sa foam cannon na soap, un na sa wash bucket para dual purpose.

Will try the chemical guys citrus wash and gloss next time.

[tribal]

I think I may have finally figured out the dilution. Haha. 1.5oz then around 300ml water. See the foam cannon below. Ganun lang gamit ko. Thick enough foam to drag down the contaminants off the paint.

noob question. how do you use that? manual pumping or you connect it to pressurized washer? Im planning to buy one too

[gls2001]

noob question. how do you use that? manual pumping or you connect it to pressurized washer? Im planning to buy one too

You need a pressure washer.


Sent from my iPhone using Tapatalk Pro

[monty_GTV]

^ lathery yata kapag ganyan na consistency. i prefer din yung ganyan at maganda lubricity, inaanod pababa yung dumi. if you have time, figure out mo din yung dilution na frothy o makapal yung bula. i saw some carwash shops na ganun yung bula pero minsan mabula lang, walang dulas at saka maduming basahan ang gamit kaya swirls lang inaabot ng pintura[emoji28]

Sent from my SM-G960F using Tapatalk

[ninjababez]

*zechs
bro wala compressor yan ? direct from faucet lang?

[zechs]

*zechs
bro wala compressor yan ? direct from faucet lang?

You need a pressure washer at the very least. But I purchased a different foam cannon (which actually cost as much as the pressure washer)

Bead maker depth and gloss (not yet dusty, starting pa lang)

[ninjababez]

aw sayang naman, di uubra pressure washer since shared sa compound ang electricity sa garage
thanks sa reply bro

- - - - - - - - - - - - - - - - - - - - - -

aw sayang naman, di uubra pressure washer since shared sa compound ang electricity sa garage
thanks sa reply bro

[gls2001]

Eto gamit ko sa paghugas and sa foam cannon. It’s a 24Vdc pressure washer 6-7mPa connected to my 24V Off-Grid setup.








Sent from my iPhone using Tapatalk Pro

[gls2001]

Ok itong Megs D300. Hindi nag dadust ng husto compared sa M105 and easier to work with. Followed by Power Lock and Collinite 845, ok na ako dito.









Sent from my iPhone using Tapatalk Pro

[zechs]

Nice results with the D300.
Is that a Sonax Perfect Finish at the back? How is it?


Jescar power lock plus and collinite 845 go to combo ni obsessed garage. Hehe

[gls2001]

Nice results with the D300.
Is that a Sonax Perfect Finish at the back? How is it?


Jescar power lock plus and collinite 845 go to combo ni obsessed garage. Hehe

No, it’s a Menzerna 3in1. Haven’t tried it yet.


Sent from my iPhone using Tapatalk Pro

[yubby24]

Hi. Don't know if this is the right thread for my question but here it goes.

May alam po ba kayong shops na gumagawa/nagkakabit ng OEM body kits? Nadamage kasi yung side skirt ng mobilio namin (own damage - sumabit sa gutter). Iniisip ko kung ike-claim ko ba sa insurance as own damage yung pagawa o hanap na lang ako ng OEM side skirt at palitan na lang.

Thanks!

[montro]

Hi. Don't know if this is the right thread for my question but here it goes.

May alam po ba kayong shops na gumagawa/nagkakabit ng OEM body kits? Nadamage kasi yung side skirt ng mobilio namin (own damage - sumabit sa gutter). Iniisip ko kung ike-claim ko ba sa insurance as own damage yung pagawa o hanap na lang ako ng OEM side skirt at palitan na lang.

Thanks!

Just claim it to your insurance. What insurance for if not using it.

Sent from my iPhone Xs Max using Tapatalk

[dr. d]

Hi. Don't know if this is the right thread for my question but here it goes.

May alam po ba kayong shops na gumagawa/nagkakabit ng OEM body kits? Nadamage kasi yung side skirt ng mobilio namin (own damage - sumabit sa gutter). Iniisip ko kung ike-claim ko ba sa insurance as own damage yung pagawa o hanap na lang ako ng OEM side skirt at palitan na lang.

Thanks!

if buying it yourself and having it installed is cheaper than the insurance's participation fee, i'd buy it and have installed without involving the insurance.

[zero3]

Planning to buy a polisher. Looking sa dewalt 849x. Ok ba sya? Anyone using it here? Saka advisable mag polisher every other week for applying spray wax or carnauba? malakas ba sa kuryente? Sensya na daming tanong.

Sent from my SM-T705 using Tapatalk

[StockEngine]

Planning to buy a polisher. Looking sa dewalt 849x. Ok ba sya? Anyone using it here? Saka advisable mag polisher every other week for applying spray wax or carnauba? malakas ba sa kuryente? Sensya na daming tanong.

Sent from my SM-T705 using Tapatalk

wax every week? which product are you using?