Detailing Thread [For Newbies][continued 2]

[jmpet626]

Actually for removing waxes and sealants, basically anything that doesn't need pressure to remove, those MF's area already great, but try to use those MF's to remove gummed on polishes and compounds and you will see it will actually instill scratches, those MF's are ok for light pressure usage but with moderate you might be a little bit disappointed, thats why we have a lot of MF's at home depending on the purpose of use, for QD and easy wax removals those are fine, but there's also a reason why we invest on the much more expensive MF's from Microtex and from abroad, BMW and mercs clear coat are very sensitive and believe me the MF's we use for them are very expensive hehe

Di ko pa na try mag remove ng gummed up polish using that MF. If applied properly yung wax and polish its ok naman. Nasa 35 pesos lang kasi lumalabas each yung yellow Mfs kung 36-pack binili.

[madkatz]

Di ko pa na try mag remove ng gummed up polish using that MF. If applied properly yung wax and polish its ok naman. Nasa 35 pesos lang kasi lumalabas each yung yellow Mfs kung 36-pack binili.

in most cases where the wax and polish is easy to remove and apply this is already enough, but with some of the Megs and Menzerna line same with Farecla they have a high tendency to gum up on high speeds with rotary and these gummed up products are usually very hard to remove often requiring a lot of elbow grease