Quote Originally Posted by african888 View Post
paano po mag diy grounding ng outlet?

- - - - - - - - - - - - - - - - - - - - - -



paano po mag diy grounding ng outlet?
You need a grounding rod. Comes in brass copper or anodized galvanized steel 5,6,8,10 ft at local electrical hardware. Drive that into the earth preferably water ground level. Connect/bond a gauge2-4 wire depends on what you are protecting, typical entrance facility at 100-200A), then connect the other end into a copper ground-bus bar for the distribution. Distribution is inside the circuit breaker box, if the existing wiring layout has no provision(3rd wire for gnd) then be creative to layout a separate wire run. It should read <4ohms at any point of your house, add additional ground rod to the opposite side if wire run is longer exceeding 4ohms. If you have a tower/mast, that should be grounded separately ideally <1ohm because direct lightning hit is very likely.