only 3 spark plugs?

**KBR** · January 24th, 2008 04:02 PM

Originally Posted by 4JGtootsie

Slow kangaroo!

Sean, if you want to experiment. Remove the whole spark plug para walang compression resistance, the injector signal para walang fuel, the whole tension wire and tape the whole on the cap para walang arching.

If you want to go further shut the running mate piston and do the same as above. Do the sa pababang road para may momentum ka. Goodluck!

one word: Missfire

lolz!

aite, peace.

**kenshinx** · January 24th, 2008 07:48 PM

Baka hindi umandar kasi di nya makokopleto ang 4-stroke cycle nya - opinyon lang :-)

**VtEC** · January 25th, 2008 03:40 AM

aandar padin naman yan pero aabot ka kaya sa pupuntahan mo.imaginin monalang ang oto mo na flat ang isang gulong.

**tip_tipid** · January 25th, 2008 04:42 AM

ang original na tanong ay "kung 3 sparkplugs lang ang nakalagay". I believe he is referring to a 4-cyl engine. So there is no sparkplug installed in one of the cylinder, and is left open. In this case there will be no considerable compression or vacuum being made in this particular cylinder. then the engine will still run, but with some noticeable vibration, and reduced power. If it is a carburator type, fuel air mixture of appreciable volume will not be sucked into the cylinder.
you will still be able to drive considerable distance in this mode.

**4JGtootsie** · January 25th, 2008 10:03 AM

Originally Posted by KBR

one word: Missfire

lolz!

aite, peace.

Im just really curious. Why would it missfire? Under power I agree!

**t2erns** · January 26th, 2008 12:15 AM

if it's obd2 it will still flag a misfire on that cylinder...why misfire? because there will no crankshaft speed variation on the power stroke of that particular cylinder.

**Memphis Raines** · January 26th, 2008 12:35 AM

The bottomline is that DONT TRY THIS ON YOUR CAR!

**4JGtootsie** · January 26th, 2008 09:36 AM

CMP is timed/meshed to CkP to be used to determine valve activity based on piston position and stroke. Without spark, fuel and compression How can there be missfire?

**speedyfix** · January 27th, 2008 09:56 AM

if you're not going to put the plug you might as well unhook the injector too.

pero this is a really bad idea in the first place.

**raine** · January 28th, 2008 06:13 PM

Experience ko ito sa 86 model lancer box type, habang tumatakbo biglang namatay ang makina, try ko start ok na ang then pagaandar na namamatay uli ang makina, nag mag check sa makina found out maluwag yung israng high tension wire ng spark plug after reconnecting ito ok na uli ang takbo.