we can check the idling once you bring the car over. same din for the alternator. minsan better kung palitan mo nalang ng buo yung alternator though since pag di tama press ng bearing sa loob bumabalik din agad yung noise.
we don't sell grounding kits but we can install them for you if you bring the kit.
Ok punta kami dyan sa shop mo, hanap muna ko ng grounding kit and alternator. thanks, happy holidays!!! tawag na lang ako para malaman ko yung quotation.
we can try to reset it but normally if the srs light comes on it means there is a problem with one of the following: airbag sensors, steering wheel or seatbelt tensioners.
resetting might remove the light but it'll show up again if may sira yung part.
Thanks for the quote sir migs re the steering and suspension repairs for my Mazda.
I'll be there Saturday morning for rack-end and front bushing replacement.
BTW, I need tune-up but can't afford your Royal Purple promo at the moment. Do you have regular non-synthetics like Magnatec?
Petron CCC Alabang (near my office lang kasi) did the timing check already and said we can't further adjust it dahil sagad na daw yung setting sa distributor, hence the need to open the timing belt assembly at re-adjust from there.
Hello sir I had the Astina's steering serviced last Saturday at your shop. Good job. Anyway, they also did a compression test. Pasado naman daw.
They showed me the oiled spark plugs which implied valve seal replacement. Mausok na kasi siya. Anyway, I'm good to go on that pero another thing that bothers me is the ignition timing kasi. Although I don't want the belt replaced yet kasi 20,000 km pa lang po yung natakbo niya.
It loses power big time especially when a/c is on.
I might visit the shop again pag hindi na ulit busy.
i called up your shop yesterday ... was asking kung how much yung release bearing and pressure plate ng corolla 96 ( 2E, 12V )
uhm, ask ko lang din sir ...
what could be the possible problems of having a hard clutch. yung kumukunat na siya ? could it be the said two ( pressure plate & release bearing ) or meron pa ibang possible causes ?
uhm, and ... tanong ko lang ulit magkano yun dalawa including labor na sana. kahit replacement/aftermarket lang ... wag na original. hehehe
most likely the pressure plate or release bearing. pwede rin either the clutch master/slave or the clutch cable (depends what your car uses).
were you able to get the price yesterday? if so then the price holds naman. for any price concerns or questions please call the shop nalang as they can give you a quote during office hours.