Bearing squeaky noise

[danegoesonline]

Nag spray ako ng water sa rib side ng belt hindi huminto ang squeak. It is very hard to determine saang bearing nang gagaling ung noise, is there anyway na malaman ko which one ung squeaking? And then pano ko malaman ung bearing na bibilin ko?


Sent from my iPad using Tapatalk

[12vdc]

Nag spray ako ng water sa rib side ng belt hindi huminto ang squeak. It is very hard to determine saang bearing nang gagaling ung noise, is there anyway na malaman ko which one ung squeaking? And then pano ko malaman ung bearing na bibilin ko?


Sent from my iPad using Tapatalk

If you are done checking the drive belts for cracks, you may remove one-by-one the drive belts to isolate the accessories (PS pump, AC compressor, alternator, WPump). Once you identified the bearing, check the part number printed on the cover then ask the bearing store for replacement. If water pump is the culprit, replace the assembly as the bearing is pressed on watertight seal.

[dr. d]

my usual bet is the idler pulley bearing.

[Archerfish]

I want that stethoscope! What do you call that thing?

[shadow]

I think OP should just bring his car to a mechanic to avoid making a mistake, if he can't find the simple squeaking sound I don't think he'll be able to do thr steps posted of removing belts and everything.


Sent from my iPhone using Tapatalk

[12vdc]

I want that stethoscope! What do you call that thing?

Mechanic's stethoschope. Nagkalat sa Lazada less than P500

[Archerfish]

Mechanic's stethoschope. Nagkalat sa Lazada less than P500

So, it is really called as a stethoscope. Thank you, I might give this as a gift to my brother who is maintaining an older car.

I remember using a copper tube whose end is pointed and the other end with a 1 cm diameter sphere. I'm​ not sure if it's called "listening rod".

[yapoy86]

Nag spray ako ng water sa rib side ng belt hindi huminto ang squeak. It is very hard to determine saang bearing nang gagaling ung noise, is there anyway na malaman ko which one ung squeaking? And then pano ko malaman ung bearing na bibilin ko?


Sent from my iPad using Tapatalk

Pwede din sa crank shaft pulley galing yung squeak.. usually pag bearing ang sira may ugong yan na tunog na parang riles ng tren

[danegoesonline]

Pwede b stethoscope ng doctor un lng meron aq

Sent from my SM-G532G using Tapatalk

[SpinCycle]

Pwede b stethoscope ng doctor un lng meron aq

Sent from my SM-G532G using Tapatalk

Pwede rin pero baka mabingi ka

Sent from my SM-G960F using Tapatalk

[Iskokikoy]

Also try checking for rust build upon the grooves of bearings as this also causes squeeks. Water method isn't always effective because you are wetting the belt and not the bearing, which is a test done for belt tension not bearing wear.

[XTO]

Nag spray ako ng water sa rib side ng belt hindi huminto ang squeak. It is very hard to determine saang bearing nang gagaling ung noise, is there anyway na malaman ko which one ung squeaking? And then pano ko malaman ung bearing na bibilin ko?


Sent from my iPad using Tapatalk

Check muna belt kung maluwag. If not tsaka punta kung bearing.

[danegoesonline]

Mga tsikoteer, pag yung squeak nag appear lang pag pkatapos patayin ung aircon at fan ano ibig sbhn? Pag initial start, walang squeak.

Sent from my SM-G532G using Tapatalk