Quote Originally Posted by simonzaide View Post
After some backreading and some research more or less im decided to go this set up

Focal flax 3 way
Focal p30
Dynaquest dt 440 (2 pieces)

No for added questions

Do i need another amp to run the sub or can i just connect if the the extra 2 channels of the other dt440

If i will go a semi active route

Tweeter and midrange to crossover on amp 1

Bass and subwoofer on amp 2

Is this possible and this means i can run this using an audison bit ten processor right ?

Another option is run a full active 3 way with a mosconi 6 to 8 ?

And add another amp for the sub alone. Would a regular 300w class d mono amp do ? Like a firland

Thanks for the replies
The Focal P30 is a single voice coil subwoofer nominal 4ohms. Just bridge two of the channels of your DT440 for it. It might not have as much power as a mono amplifier but it'll work. In fact, I'll recommend you stick with this setup rather than purchasing a mono amplifier for it. The only time you need a mono amplifier is when you need more power and stability at lower resistance/ohms.

Your Dynaquest DT440 is a four-channel amplifier. Having two of them means you have 8 channels to play with. What I recommend is that you go for full-active 3-way by upgrading your Bit Ten to a Bit One or equivalent (like your mentioned Mosconi 6to8). Since nandyan ka na rin sa point na yan, might as well splurge a few more.

In case you're fearing you'll need more power, just make your subwoofer box bigger.