Detailing Thread [For Newbies][ARCHIVED]

[archerwin]

me nakikita nga ako na gumagamit ng 3m na scotch brite., i wonder kung di nagagasgas un salamin nila., ako microfiber lang gamit ko.,

sigurado gasgas yun!

[ronald_m]

dagdag lang... yung clearkote VM, sealant ba yun? is that good?

I used vanilla moose,It's a glaze.You can top it off with S100 or sealant.The result is deep wet look.

[ronald_m]

Paint Sealant ?

Since the Klasse SG is hard to come by here in the PHI, just want to ask your opinion on the ff paint sealants:
1. Fusso/Gekko - Soft99 - what is better?
2. Meg#21 - Polymer Sealant
3. Meg Nxt Wax - Sealant daw pala ito

of the 3 listed above, what is better? do you know of any other sealants that are available in the PHI that is better than the 3 above?

thanks!

#3 .

[theveed]

Protection: Soft99
Ease of use on a undetailed car: NXT
Somewhere in the middle (paint clean): 21.

[archerwin]

theveed,
ano yung mas ok, yung fusso or yung gekko? thanks!!!!!!!!

[theveed]

Gecki, pre hehe... Not much diff actually...

Gecko butiki yun :D

[archerwin]

ay oo nga... hehehehe thanks!

[nat2x]

ndi nagasgas., naigno nga ko nung pinanuod ko., astig parang bago ung window nya after nya gawin un., parang wax un solution na nilagay nya., tapos harsh un pag scrub nya., natakot nga ako na baka magasgas, pero hindi.,

[jacorb_88]

i did shopping last friday:

1. ElastiClay from Big Bert's
2. Mother's Power Polish - I was supposed to buy Meg's DACP but out of stock
3. Mother's SynWax
4. Mother's Reflections QD
5. EO 20/20
6. 3M IHG - 2 packs
7. 3M RC - 1 pack

I started 9am, finished at 7pm. Managed to detail the paint only. Pain from all angles of my body. The hardwork was well-worth it. Tomorrow, I'll finish the windows.

I have Klasse twins coming over next weekend.

My question is: what should I do before applying Klasse AIO and SG? Currently, my ride has SynWax on top.

[ILuvDetailing]

My question is: what should I do before applying Klasse AIO and SG? Currently, my ride has SynWax on top.

Start off with AIO, then S & G, let it cure for 24-48hours then apply an LSP (Last Step Product)>> Mother's SynWax.