Huper Optik Tint

[erick_214]

Hi Sir Ndoyman,

Inquire lang ako tungkol dito sa tint nyo. Since yung iba nagkakaproblema sa pag-install dahil sa paggamit ng heat gun eh pwede bang huwag na gumamit ng heat gun para maging 100% worry free talaga? Tsaka anong shade ba yung may highest heat rejection?

Thanks

[number001]

the darkest shade will usually give you the highest heat rejection.

[NdoymaN]

the darkest shade will usually give you the highest heat rejection.

Yes po.. usually ganun po sila talaga pero sa Huper Optik, yung Ceramic 15 po yung me pinakamataas na heat rejection.

Ceramic 05 kase 92% lang unlike Ceramic 15 96% po sya..

HTH

[red_one]

WINDOW FILM TEMPERATURE TEST REPORT

Window Film Temperature Test Report « Window Tinting Blog | Vision Quest Distributing

EFFECT OF DYED FILMS -VS- CERAMIC SOLAR CONTROL FILMS ON VEHICLE INTERIOR TEMPERATURE

FILMS USED FOR THE EXPERIMENT



RESULTS

The maximum temperatures attained are given in Table 4, while Appendix 1 shows the temperature curves over time for the front and the rear of the car respectively.



ANALYSIS

The results clearly show that the temperatures for the Hüper Optik film combination kept the car coolest when compared to no film applied and to dyed films.

FILM VS NO FILM

The Hüper Optik’s C70+C15 combination kept the front and rear of the car 12.7°C and 7.9°C cooler respectively than the car without any film. This is a very significant result as it shows that even after 120 minutes of exposure to the halogen light source, the Hüper Optik films still maintained a significantly lower temperature, about 22% and 15% cooler for the front and rear respectively compared to the control situation where no film was installed. While the 3X films also kept the car cooler than a car without film, the extent of the heat rejecting effect was less than the single-layer Hüper Optik films. 3X films only resulted in a temperature drop of 7.8°C and 2.8°C for the front and rear of the car respectively. This infers that in an actual situation where a car is parked under the sun for a long time, it is important to install films that can keep the car interior cool so that the driver will not feel major thermal discomfort when he enters the car. The air-conditioning also takes a shorter time to cool down when it is switched on after a prolonged period of exposure to the sun.

[red_one]

*NdoymaN: sent you PM bro.

[red_one]

para sa mga fellow members na mahilig sa number

[NdoymaN]

*NdoymaN: sent you PM bro.

Yes Sir. I emailed you the details po. TIA

[NdoymaN]

Hi Sir Ndoyman,

Inquire lang ako tungkol dito sa tint nyo. Since yung iba nagkakaproblema sa pag-install dahil sa paggamit ng heat gun eh pwede bang huwag na gumamit ng heat gun para maging 100% worry free talaga? Tsaka anong shade ba yung may highest heat rejection?

Thanks

Hi Sir Erick!

Actually po, kung pupwede lang di na iheat gun yung film why not di ba? kaso kase yung surface ng glass panels po naten mejo concave po sya kaya talaga need po nateng iheatgun kundi po, hindi sya lalapat at magkaka bubbles syang malaki.. kung mapapansin nyo po, sa mga side panels nyo po hindi na hiniheatgun kase mejo flat po sila..

BTW, highest heat rejection po is Ceramic 15.

HTH