Welcome to all owners of Toyota Fortuner [continued]

[dr. d]

babalik talaga bro pag walang clear coat
dahil natanggal ang clear coat nya kaya sya nanilaw / lumabo

eto hanggang mabenta malinaw parin [emoji16]

Sent from my MI MAX 3 using Tapatalk

errr,
bakit nyo binenta yung vios, in favor of the altis?
OT.

[ninjababez]

errr,
bakit nyo binenta yung vios, in favor of the altis?
OT.

need for speed [emoji1787][emoji1787]

Sent from my MI MAX 3 using Tapatalk

[Egan101]

errr,
bakit nyo binenta yung vios, in favor of the altis?
OT.

The Altis is a better car overall than the Vios, much like the Civic over the City.


Sent from my iPhone using Tapatalk

[falken]

Cataract on headlights. (The lens assembly is clear). Ano ang cause at pano/saan ang pa rapair?

Sent from my SM-N9500 using Tapatalk

Mix some baking soda and white

Sent from my SM-T725 using Tapatalk

[falken]

Cataract on headlights. (The lens assembly is clear). Ano ang cause at pano/saan ang pa rapair?

Sent from my SM-N9500 using Tapatalk

Mix some baking soda and "white" toothpaste, not the colored or gel ones. Wet the headlight then apply. Use a toothbrush to scrub or your fingers to rub. It took me 30 minutes for it to come off, although not 100%. Rinse with water. You can repeat again if necessary. Just put sealant on your headlight after the final scrubbing.

Sent from my SM-T725 using Tapatalk

[travajante]

Mix some baking soda and "white" toothpaste, not the colored or gel ones. Wet the headlight then apply. Use a toothbrush to scrub or your fingers to rub. It took me 30 minutes for it to come off, although not 100%. Rinse with water. You can repeat again if necessary. Just put sealant on your headlight after the final scrubbing.

Sent from my SM-T725 using Tapatalk

^This hack or the 1 below....



Once they've been touched, they'll never stay pre-defloration for long. Headlamp PPF can serve as chastity belt on virgins before they happen or right after the rubbing.[emoji4]

[dr. d]

...but even if we can clean and polish the outer surface, there's still the inner surface...

[travajante]

...but even if we can clean and polish the outer surface, there's still the inner surface...

The yellow I've seen is on the outer. A combo of fine scratches from nonOCD washes(I prefer to use different mitts/Mfiber cloths for the body & lenses) & UV oxidation. Both will accelerate grime & contaminant buildup. Solar & lamp heat are catalysts for baking the buildup to a good cure onto them plastic lenses.
I miss the good ol' glass-lenses. They never age.

Sent from my SM-G970F using Tapatalk

[hdj80]

Here’s some pics of my new fortuner G with the KS LEDs in the projectors.

[StockEngine]

that adjustment is not good. you will get the fury of other drivers and pedestrians.

[hdj80]

that adjustment is not good. you will get the fury of other drivers and pedestrians.

Whats funny is that what you see is the factory headlight adjustment. They intentionally made it higher than normal to compensate for the very weak throw of the stock halogen bulbs.

Already adjusted the aim a few degrees lower since its using LEDs.


Sent from my iPhone using Tapatalk

[dr. d]

Whats funny is that what you see is the factory headlight adjustment. They intentionally made it higher than normal to compensate for the very weak throw of the stock halogen bulbs.

Already adjusted the aim a few degrees lower since its using LEDs.


Sent from my iPhone using Tapatalk

parang masyadong mataas.
the low beam throw appears almost horizontal.
i lowered my innova's factory setting, as i found the low beam "too horizontal".
i also adjusted the left headlight to veer slightly to the right.
.

[hdj80]

too much stray light, in my opinion.
is it possible, your headlight housing is not designed for LED?

Its a projector housing and not reflector so it should be fine. I checked cutoff at 25 ft and it seemed ok


Sent from my iPhone using Tapatalk

[hdj80]

parang masyadong mataas.
the low beam throw appears almost horizontal.
i lowered my innova's factory setting, as i found the low beam "too horizontal".
i also adjusted the left headlight to veer slightly to the right.
.

The stock beam height is too high right? Thats a weird thing with the new toyotas. Taas ng aim ng lights.


Sent from my iPhone using Tapatalk

[dnonable]

Does anybody know what audio brand is installed on the Fortuner?

Sent from my SM-N9500 using Tapatalk

[yapoy86]

Does anybody know what audio brand is installed on the Fortuner?

Sent from my SM-N9500 using Tapatalk

AVT din yata

[c-4]

Where to go for AC cleaning? CASA cost is PhP 10k. Thanks!


Sent from my iPhone using Tapatalk

[johann123]

Where to go for AC cleaning? CASA cost is PhP 10k. Thanks!


Sent from my iPhone using Tapatalk

Have you tried cleaning/replacing the cabin filter first? Mahina na ba ang buga at wala ng lamig?

Sent from my Redmi Note 5 using Tapatalk

[c-4]

Have you tried cleaning/replacing the cabin filter first? Mahina na ba ang buga at wala ng lamig?

Sent from my Redmi Note 5 using Tapatalk

No observed issue so far. Just basing it on the 45k PMS. Cabin filter, I think kaya naman ng linis muna.

[dr. d]

Where to go for AC cleaning? CASA cost is PhP 10k. Thanks!


Sent from my iPhone using Tapatalk

why are you thinking of having your aircon cleaned, po?

i remove and clean my (innova's) aircon filter myself.
gentle hand wash lang with tide or breeze.
i do it at one year intervals, or until it seems too distorted already.

it may seem easy, according to youtube.
but in truth, to the newcomer, it is not, at first try.
it would feel as if something may break, because it really needs some strong muscle to remove the glovebox.
but nothing will break. it just needs some practice.

after 12 years, i finally consented to have them open and clean my aircon, "because it's 12 years old already".
well, it was still very clean.
my advice is, don't have them "clean it" until the aircon don't seem to be cooling anymore, and replacing the filter and adding freon don't do the job anymore.

good luck.