Strada PMS thread [ARCHIVED]

[altec]

Ay 160 ba sabi ko? Sabi ko 60 lang. Nagkamali lang pindot. Haha. Saan ka ba nagpagawa? Share naman diyan KOYA!!

wobble at 60kph, its an alignment or front suspension problem. Normally, pag may diperensya ang pitman, ball joint, front suspension,etc the shop cannot align until the defective part is replaced. Wobble at 100kph, tire problem yan, balancing.

[beni23]

shaking steering wheel = two things
1. may problema na steering mo
2. magpabalance ka na ng gulong.

camber correction and wheel alignment.... do not bother having it done sa casa... you're better off bringing it to a servitek station. Sure, baka makalibre ka sa casa, pero believe me, babagsak ka lang din sa talagang nag cacamber and wheel alignment.


tire rotations, please do it every change oil or every 5K km. kung stock pa lahat ng gulong including spare, do the 5 wheel rotation, kung nagpalit ka na ng 4, do a 4 wheel rotation... kung nagkataion na may bias pattern ang tread ng mga bagong gulong, medyo may problema ka na nyan...heheheheh doble gastos na yan kasi kailangan mo na ipa mount/unmount yung goma mo para tumugma sa tamang tread direction

Wohw wohw, every 5k PMS pala ito. Since nabili namin itong strada hindi pa ata napaparotate / camber and wheel alignment ito. Definitely, ipapagawa ko na to agad. Every uwi ko ng probinsya at pinapatakbo ko to ng mga 160 - 180 km/h nagwawobble talaga siya.

tama si ninong, every 5k kms din yung advice for tire rotation

wobble at 60kph, its an alignment or front suspension problem. Normally, pag may diperensya ang pitman, ball joint, front suspension,etc the shop cannot align until the defective part is replaced. Wobble at 100kph, tire problem yan, balancing.

No sir, I was just kidding about the 60 km/h. Hehe. It's 160 km/h talaga.


Thank you mga Ninong!!!

[marlowem]

5k PMS Diamond Motors Marcos Hiway

They also checked the uneven stance of my strada - 12mm and 11mm (tolerable variance is 10mm) so they ordered the suspension parts sa planta and tawagan na lang daw ako kung kailan ko dalhin for installation.

But wait! There's more... they will also install a leafspring silencer for my strada FREE OF CHARGE, kasama na sa pagpalit ng suspension parts to correct the uneven stance...

Thats not all! (hehehe, pang infomercial na ang dating ko ah!)... they also gave me a VIP Card for additional discounts for my succeeding visits... 35% off sa parts and 15% off sa labor... NOT BAD AT ALL!

Kilala na ang Strada Club dun... pati guard on duty nag-greet agad sa akin pagdating ko, he was asking kung madami na daw tayong members... dami na kasi tayong members na kumuha ng strada sa kanila eh...

Sir sino po SA niyo sa Diamond Marcos? Papatingnan ko po 'yung uneven stance. Medyo matagal ko na napapansin na parang tabingi 'yung strada ko pero medyo 'di ko sineseryoso hanggang nung may kinargang mabigat nung isang araw at naka-full tank hehe

[Walter]

Sir sino po SA niyo sa Diamond Marcos? Papatingnan ko po 'yung uneven stance. Medyo matagal ko na napapansin na parang tabingi 'yung strada ko pero medyo 'di ko sineseryoso hanggang nung may kinargang mabigat nung isang araw at naka-full tank hehe

Good luck, the first thing they will tell you is that the height difference is within spec.

[pransis]

25,000 KM PMS performed at Mitsubishi Motors Balintawak:

PMS Labor - Php 1,312.74

Materials
7L Fully Synthetic Oil (Motul CRDi) *450 per liter - 3,150.00
CCK1 - 280.00
4L Mineral Oil (used to flush out the mit oil.) - 852.00

Parts
Oil Filter - 1044.24
Gasket, Engine Drain - 40.32

Performed EGR/Intake Cleaning (their machine wasn't available when they previously performed my 20,000 PMS) - 3,200.00

TOTAL Php 9,879.30
Less 30% Discount on PMS labor and discount on parts - 822.28

GRAND TOTAL - Php 9,057.02

[JayBel]

Gud evening mga sir. Itatanong ko Lang po kung kailangan talaga ang tire rotation or pwede namang hindi every 5K PMS? Hindi ba mejo mabigat sa bulsa pag sabay-sabay nagpalit ng gulong? Naisip ko kasi na ubusin muna ang front tires para 2 tires Lang kailangan bilhin at hindi biglaan na 4 tires ang bibilhin. Then ilipat sa harap yung lumang tires at sa likod yung bago. What are your thoughts on this mga sir? TIA

[Arvin Cristi]

Gud evening mga sir. Itatanong ko Lang po kung kailangan talaga ang tire rotation or pwede namang hindi every 5K PMS? Hindi ba mejo mabigat sa bulsa pag sabay-sabay nagpalit ng gulong? Naisip ko kasi na ubusin muna ang front tires para 2 tires Lang kailangan bilhin at hindi biglaan na 4 tires ang bibilhin. Then ilipat sa harap yung lumang tires at sa likod yung bago. What are your thoughts on this mga sir? TIA

sir wala namang gastos mag rotate ng gulong eh. acatually dapat lahat nga ng vehicle owners marunongnito, kasi parang nag palit ka lang ng gulong na flat, pero this time may tamang sequence yung paglagay ng mga gulong. it won't take you more than an hour to do a 5 wheel rotation.

and please take note pag magpapalit ng mga lumang gulong, ang pinaka magandang gulong ang dapat lagi nakalagay sa harap, dahil yan ang nag dadala ng buhay mo pag sinabugan ka pag luma ang gulong mo sa harap

[JayBel]

sir wala namang gastos mag rotate ng gulong eh. acatually dapat lahat nga ng vehicle owners marunongnito, kasi parang nag palit ka lang ng gulong na flat, pero this time may tamang sequence yung paglagay ng mga gulong. it won't take you more than an hour to do a 5 wheel rotation.

and please take note pag magpapalit ng mga lumang gulong, ang pinaka magandang gulong ang dapat lagi nakalagay sa harap, dahil yan ang nag dadala ng buhay mo pag sinabugan ka pag luma ang gulong mo sa harap

Sir, salamat po sa info. I'll keep that in mind.

[ThePatriarch]

Sir sino po SA niyo sa Diamond Marcos? Papatingnan ko po 'yung uneven stance. Medyo matagal ko na napapansin na parang tabingi 'yung strada ko pero medyo 'di ko sineseryoso hanggang nung may kinargang mabigat nung isang araw at naka-full tank hehe

Good luck, the first thing they will tell you is that the height difference is within spec.

Diamond Quezon Ave na ako napapa-service, look for Aurelio Parado and tell him TSCP member ka... dont worry hindi ka bobolahin nun

[GAIDEN]

look for Aurelio Parado and tell him TSCP member ka... dont worry hindi ka bobolahin nun

Sir President, may discount or perks po ba mga club members dito?

[Pol-pol]

25,000 KM PMS performed at Mitsubishi Motors Balintawak:

PMS Labor - Php 1,312.74

Materials
7L Fully Synthetic Oil (Motul CRDi) *450 per liter - 3,150.00
CCK1 - 280.00
4L Mineral Oil (used to flush out the mit oil.) - 852.00

Parts
Oil Filter - 1044.24
Gasket, Engine Drain - 40.32

Performed EGR/Intake Cleaning (their machine wasn't available when they previously performed my 20,000 PMS) - 3,200.00

TOTAL Php 9,879.30
Less 30% Discount on PMS labor and discount on parts - 822.28

GRAND TOTAL - Php 9,057.02

[SIZE=3]Bad trip talaga, I was really taken for a ride dun sa Oil Price ng Casa.

Sir pransis, recommended ba yung EGR cleaning due to performance issues being experienced or you just wanted it done? Nakaka-alarm, kasi 25Tkm ka pa lang.

My truck is at the 30Tkm+ mileage and I feel a slight weird surging sometimes hesitation feeling with my engine. However, sabi nung SA wala naman daw.

BTW, I was told J.R. (Diamond Valle) is undergoing training and will be unavailable until October (yata).

[/SIZE]

[ThePatriarch]

Sir President, may discount or perks po ba mga club members dito?

hehe, sabihin ko sa iyo sa mini-EB

[ThePatriarch]

[SIZE=3]Bad trip talaga, I was really taken for a ride dun sa Oil Price ng Casa.

Sir pransis, recommended ba yung EGR cleaning due to performance issues being experienced or you just wanted it done? Nakaka-alarm, kasi 25Tkm ka pa lang.

My truck is at the 30Tkm+ mileage and I feel a slight weird surging sometimes hesitation feeling with my engine. However, sabi nung SA wala naman daw.

BTW, I was told J.R. (Diamond Valle) is undergoing training and will be unavailable until October (yata).

[/SIZE]

even new stradas are prone to EGR/SCV failure because of our dirty diesels... pauland's 6 months old GLS sport is an example... biniro ko nga siya na baka luma yung binigay na unit ni xavier sa kanya hahahaha

ganyan din ang symptoms nung strada ni pauland... at third gear and nakatapak siya continously sa silinyador, may hesitation while accelerating... na-diagnose agad sa Diamond Q. ave and pinalitan agad yung parts

[beni23]

Diamond Quezon Ave na ako napapa-service, look for Aurelio Parado and tell him TSCP member ka... dont worry hindi ka bobolahin nun

Since unang pagawa ko dun DMC QA siya na ang SA ko ni, hindi man lang siya nagsabi na siya pala gumagawa sa strada ng pres natin. Haha. BTW, wala pa ata siya dun at nagkaleptospirosis daw siya sabi nung kaibigan niyang si Roger Talagtag, kaya siya muna SA ko ngayon.


Nagawa na pala yung strada ko, may hindi lang pantay na pintura dun sa right part (mas dark) kaya ibabalik ko pa sakanila. Hehe.

[locoroco777]

Nagawa na pala yung strada ko, may hindi lang pantay na pintura dun sa right part (mas dark) kaya ibabalik ko pa sakanila. Hehe.

dapat talaga binutas na natin yung bumper mo....hahahha!

[beni23]

dapat talaga binutas na natin yung bumper mo....hahahha!

Oo nga bro. Pagkakamali ko dun dinala ko agad sa casa. Haha! Sabi ko dun sa nakabangga, "banggain mo ulit ako, sa likod naman please?" Hahaha :bwahaha:

[martin2ez13]

ask ko lang mga boss due to my banga sa front of the car the airbag light sa dash is naka on tried to reset the car nandun pa din what kaya problem nun, and may i ask how much are the brake pads for our trucks mine is about to retire na eh may after market pads na ba para satin like enless or project mu?

[locoroco777]

ask ko lang mga boss due to my banga sa front of the car the airbag light sa dash is naka on tried to reset the car nandun pa din what kaya problem nun, and may i ask how much are the brake pads for our trucks mine is about to retire na eh may after market pads na ba para satin like enless or project mu?

alam ng casa gagawin dyan bro...dalin mo nalang...

dun naman sa break pads...kung may kasyang Endless or PM....why not?

pero pwede naman yung tokico na OEM....around 6k yun...

[martin2ez13]

yun nga eh sa orig na price of 6k why not a after market na meron ba? haha

[locoroco777]

yun nga eh sa orig na price of 6k why not a after market na meron ba? haha

di ko lang sure bro...hehehehe