Mainit Masyado ang Rims

**catgreg2k2** · February 7th, 2005 06:20 PM

Guys, help naman po. Yung sasakyan ko grabe init ng front rims nya eh ang tinakbo ko lang naman is from Novaliches to Makati. Ano kaya problema nito. Pina-check ko siya nung week-ends, medyo stack-up yung gulong may ginawa yung mekaniko medyo nawala yung stackup but mainit pa rin siya. Nag-start lang ito nung nagpa-overhaul ako ng brakes ko, pinapalitan ko yung break pad at piston break ba yun. Ano po kaya problema nito? Please help naman po. Thanks.

**1D4LV** · February 7th, 2005 06:23 PM

baka mahigpit ang pagkakabalik ng pads. pero dapat nangangamoy yun. not sure din kung may direct relation sa pag-init ng temperature ng mags/rims.

**BlueBimmer** · February 7th, 2005 06:28 PM

definitely cos of brake pads, but no idea why, onga baka mahigpit lalo na if new pads.

**theveed** · February 7th, 2005 06:31 PM

or baka stuck up yung isang brake caliper mo.

**crossback** · February 7th, 2005 06:36 PM

try doing this....

jack mo yung gulong, tapos paikotin mo... dapat FREE wheeling sya... if not, somethings wrong with your break system.. could be your caliper.

i was told that this could cause some serious trouble... patingnan mo nalang sa mekaniko...

**alwayz_yummy** · February 7th, 2005 06:40 PM

nagpalit bA ng repair kit?baka di maganda pagkagwa nyan..kasi based on my experience,kahit nonstop dirving,di iinit yan..kahit stop-and-go traffic..pa-bacjob mo..kung di bak masabugan ka ng gulong due to exessive heat..

**baiskee** · February 7th, 2005 06:59 PM

yup..pa backjob mo yan. what more kung biabiyahe ka pa more than the novaliches-makati route.

tires are the only contact point of the car to the ground.

**chieffy** · February 7th, 2005 07:40 PM

ibalik mo na agad sa gumawa...baka may tama na calipers mo...kailangan na palitan yung kit at di lang pansamantalang remedyo tulad ng ginawa ng mekaniko...

mas mabuti na yung problemang di umandar kaysa di ka huminto dahil nasira na ang preno sa sobrang init na dulot ng faulty brake system...disgrasya aabutin mo...

**OTEP** · February 8th, 2005 10:24 AM

Baka nga kailangan lang ng caliper rebuild kit.

Hindi naman iyon ganun kamahal.

**catgreg2k2** · February 8th, 2005 10:42 AM

thanks for your advice guys, actually na-try ko na rin i-jack. Ang alam ko nga dapat free wheeling sya but on my observation hirap siya umikot. Napansin ko din na dikit na dikit nga yung pad ko dun sa plate. Guys any shop na mapagkakatiwalaan to do this job yung mekaniko ko kasi may kalayuan sa may amin. Thanks.

**BlueBimmer** · February 8th, 2005 10:44 AM

stuck brake piston? happened to my civic dati hehe just guessing

**luckytruck** · February 8th, 2005 10:51 AM

did you change your rims? baka mali ang offset?

andy

**catgreg2k2** · February 8th, 2005 10:52 AM

guys tanong ko lang, may kinalaman ba yung problem ko sa break master? Kasi nagpalit din ako ng brake master eh. sorry ngayon ko lang naisip ito. di ko na nasabay sa post ko sa taas. thank you po ulit.

**alwayz_yummy** · February 8th, 2005 12:23 PM

malamang....check the all,e..backjob mo..just to get your money's worth..next time,kung maari,sa iba ka na magpagawa...

**OTEP** · February 8th, 2005 12:25 PM

Speedyfix in Pasong Tamo or GlennSter's shop in QC ang mga shops na naiisip ko ngayon.

**ssaloon** · February 8th, 2005 06:11 PM

speedyfix pasong tamo? hindi ba sa santolan sila? :D

**catgreg2k2** · February 9th, 2005 10:29 AM

Ok, thanks everybody. This weekends puntahan ko si speedyfix.

**afrasay** · February 10th, 2005 08:22 AM

baka hindi naka align brake pistons. tabingi then nag stuck na. There is also such a thing as the pads being too thick for your disk. Check your wheel bearings too. A little heat is normal as the pads are always in contact with the rotor disk.

The Largest Car Forum in the Philippines

Mainit Masyado ang Rims

Thread Tools

Search Thread

Display

Hybrid View