Mga sir saan ang jack stand points for GSR? Medyo nayuyupi kasi under sills pag ginamitan floor jack.
Mga sir saan ang jack stand points for GSR? Medyo nayuyupi kasi under sills pag ginamitan floor jack.
Guys ano problema kapag cold start sobrang baba ng rpm. Pagkatapos ng 5-6 seconds tska lang tataas yung rpm. Dati kasi mga 1-2 seconds lng delay bago tumaas. Kapapalit lang ng idle servo at kalilinis lang ng throttle body. Tenkyu
Hi! Question lang... May problem kasi Lancer ko. May pawala walang uga akong nararamdaman sa bandang harap. Dati nung naramdaman ko yun is kapag tumatakbo na kami ng around 80kph. Ang sabi sakin nung mechanic ko eh engine at transmission support yun kaya I had it replaced. Pero ngayon kasi mas malala na yung ugang nararamdaman ko. First ko syang naramdaman last week loaded yung car, tapos running at around 40 kph ang lakas nung alog. Sinubukan ko nang ako lang sakay ang eventually nawala. Pero recently kahit ako lang passenger meron pa ring alog. Iniisip ko is baka sa brake na baka nagsstuck up. Nagtanong ako sa mechanic ko baka raw rubber bussing meron namang nagsabi na baka raw tierod. Nababother ako kasi di ko magamit yung unit ko. Please help me.
have the suspension checked, sir. alignment and wear. baka kailangan nang re-alignment, o magpalit ng piyesa..
have the tires checked, also. baka oblong na.
- - - - - - - - - - - - - - - - - - - - - -
have the suspension checked, sir. alignment and wear. baka kailangan nang re-alignment, o magpalit ng piyesa..
have the tires checked, also. baka oblong na.
have you replaced your air filter and spark plugs?
if yes, check the condition of your high tension wires.
- - - - - - - - - - - - - - - - - - - - - -
have you replaced your air filter and spark plugs?
if yes, check the condition of your high tension wires.
Mga sir, hello po. baguhan po ako at mag tatanong lng po ako. anong generation ng 4g63t ang kasya sa lancer glx 2000 A/T, at saan po mkakakita ng ganung engine? bumibigay na po kc ang tranny at nagsusunog na po ng langis ung makina, naisip ko po nag gawing project at subukan gawing evo 5 o 6.yung bubuoin over the years pero uunahin ko po muna ung makina at icoconvert sa manual. nakita po ako sa web na isang warehouse in manila na nagbebenta po ng iba't ibang engine. alam nio po ba kung active/bukas pa yun o kung may ibang mabibilhan ng ganung makina?
Mga kamitsu what po kya ung problem pg nababasa ung flooring sa tbi ng driver seat?pag inaangat q ung mat basa po ung ilalim.thank u po.
- - - - - - - - - - - - - - - - - - - - - -
1. kailangan nang palitan ang rubber weatherstrip ng driver door.
2. may tulo na ang front windshield weatherstrip.
3. damaged katawan.. hindi pulido ang repair.
4. hindi nakasuksok ang aircon drain hose sa butas.. dun tuloy sa driverside tumutulo.
Try checking the following:
1. Air-conditioning system - could be from the drain line or deteriorated insulations. Check carefully all lines specially the drain line if it was properly inserted thru the floor
2. Floor Drain plug - might be loose or missing causing water from the outside to seep in
3. Defective or rusty flooring - presence of rust holes casing water from the outside to seep in
- - - - - - - - - - - - - - - - - - - - - -
Try checking the following:
1. Air-conditioning system - could be from the drain line or deteriorated insulations. Check carefully all lines specially the drain line if it was properly inserted thru the floor
2. Floor Drain plug - might be loose or missing causing water from the outside to seep in
3. Defective or rusty flooring - presence of rust holes casing water from the outside to seep in
Good day po, sobra po mausok (black smoke) at amoy gasolina yung lumalabas sa exhaust pipe at napakalakas sa gas nung Lancer EL 98 ko (3km/L) , dinala ko po sa mekaniko at sabi nya iaadjust daw nya yung hangin (A/F screw), so pinihit nya ng pinihit yung screw, then medyo nabawasan nga yung black smoke.
Then after 1 day, ayaw umandar nung car, nag sstart, then mamamatay agad. Sinilip ko yung carb at nawawala na pala yung A/F screw. Napasobra yata ang pihit nung siraniko kaya malamang nahulog na yung screw. Cry
Itatanong ko lang po kung kasama ba sa carb repair kit yung A/F screw? If not, saan kaya makakabili nito?
Eto po yung pansamantalang screw na inilagay nung mekaniko. Masikip po masyado kaya di maipasok. So far, naandar naman yung lancer ko, pero sobrang mausok (Black Smoke) at parang mahina ang hatak at mabagal mag accelerate.
![]()
- - - - - - - - - - - - - - - - - - - - - -
bakit mukhang parang halos babagsak na yang screw na yan? is that how the mechanic left it, po? you can see from the difference in shine, by how much he unscrewed it..
and... i do not remember seeing that screw is included in the (non-lancer) repair kits that we used to buy.. i hope i am wrong.
i think you may be better off if you had the carburator removed and overhauled. baka may bara..
Last edited by dr. d; September 24th, 2015 at 12:16 PM.
Sir temporary screw lang po yan, inilagay nung mekaniko para lang umandar yung car, kasi di naandar pag wlang screw. Right now naghahanap pa po ako nung totoong A/F mixture screw.
- - - - - - - - - - - - - - - - - - - - - -
Sir temporary screw lang po yan, inilagay nung mekaniko para lang umandar yung car, kasi di naandar pag wlang screw. Right now naghahanap pa po ako nung totoong A/F mixture screw.
Mga boss pwede ano kay problema ng lancer ko akyat baba un rpm nya tas namamatay kun bukas ang aircon po. 4g92 a/t tinitingan ko un pics nun nag bypass ng servo mukhang magkaiba namn. Pwede ko bang ipabaypass ito. Pareho din ba un bibilhin kong gagamitin kun sakali.
Hey Guys, with 6 years of my driving experience of my mitsubishi lancer 1997, I was so amazed by the people of San Jose del Monte Bulacan as I've seen a lot of Mitsubishi cars especially 1997 & 1998 models. They are good customizers thats why I always go back to this place and have sometime watching those cars passing by and hoping one of this days could have my car customize too. More power to all the Mitsubishi car owners of San Jose Del Monte Bulacan.