Facelifted 2010 Kia Rio

[ugliest]

yung parang tunog ng diesel engine tak tak tak parang disel nga pero after 20 seconds wala na sabi nga daw e sa hla daw kasi ndi pa umaakyat langis ganun daw yun pag ndi masyado ginagamit ang car,lahat nga klase gas nasubukan ko na pag sa shell unleaded sobra tahimik makina,pag premium ok lang pero mejo lakas gas minsan 8km/ltr. lang ndi kaya sa clutch kasi hirap timplahin clutch

Di ko pa naencounter yung ganyang tunog pero sa experience ko yung tunog kapag nagstart sa umaga is parang naka-rev yung makina then a couple of few seconds mawawala na din baka ito yung sinasabi nilang hindi pa umakyat yung langis. Masasanay ka din sa clutch niyan, ganun din problema ko before. Kaya tayo natatakawan sa gas dahil sa primera, or yung times na nagtitimpla ka ng clutch. Pero kung dire-diretso sobrang ok yung consumption.

Guys, idiot question. 20" and 18" ba yung size ng wiper blades natin? Hehe wala kasi ako makitang pang-measure dito sa office. Balak ko kasi magpalit to flat wiper blades (silicone). Anybody who'd already tried this?

[timo07]

yung parang tunog ng diesel engine tak tak tak parang disel nga pero after 20 seconds wala na sabi nga daw e sa hla daw kasi ndi pa umaakyat langis ganun daw yun pag ndi masyado ginagamit ang car,lahat nga klase gas nasubukan ko na pag sa shell unleaded sobra tahimik makina,pag premium ok lang pero mejo lakas gas minsan 8km/ltr. lang ndi kaya sa clutch kasi hirap timplahin clutch

Well, meron din akong napapansin na ganyan pero banayad lang naman at sandali lang. Kapag nakasettle down na sa Low idle speed nya (below 800 RPM) eh pino na yung makina. Upon initial start kasi sa morning eh nasa 1000+RPM. During the early days, I'm getting almost 10km/li pero ngayon nasa 9 na lang, minsan 8+. Dahil siguro sa sobrang traffic. Masasanay ka rin sa clutch. Dati pag umarangkada ako nasa 2000 RPM pero ngayon tantyado ko na sa mga 1000 to 1500 RPM.

[renzo_d10]

Ganda ! Hindi siya OA. Hindi rin siya ganun ka-chunky.

But then again, kits = added weight.

Kailangan ng performance mods to back up the additional weight that was added by the kits. Kahit simpleng IHE lang + Unichip. :thumbup: Para tigas din ng tunog from the muffler pag rumerekta. ;)

[karlo4real]

[ugliest]

Wow! Just wow! Hopefully I can also shell out some dough to put on some upgrades on my Rio. You did an awesome job self-facelifting your Rio Sir...

[pen_Quin6138]

Wow! Just wow! Hopefully I can also shell out some dough to put on some upgrades on my Rio. You did an awesome job self-facelifting your Rio Sir...

Wow din ako! Danda danda naman!
Congrats on your project, super looker! True Carbon Fiber hood ba yun? How much nakuha niyo sir Karlo?

[feanacta25]

Wow din ako! Danda danda naman!
Congrats on your project, super looker! True Carbon Fiber hood ba yun? How much nakuha niyo sir Karlo?

mukhang civic na sya ganda

[ziege1125]

Hi Guys,

Just got my kia rio april 29th 2011 at 7pm, i just like to know if the rio club is been already launched?

I was planning to change my horns first and pur some support on the suspension such as strut bar and lower bars front and back..

next would be the sideskirts as i dont knwo yet where you guys got the aftermarket one's.

please let me know the link for the kia rio club.

thanks

[ziege1125]

Sir Karlo,

San mo nabili yung mga strut bar yung mga pangilalim na support, i want to buy for my rio din eh pra stable sya.


let me know if i cna order na lang sayo.

thanks

[karlo4real]

guys kung may facebook kayo meron tayong facebook, type nio lang Club Rio Philippines, madaming online dun pwede tyo mag tanungan about rio..

pen_Quin6138 yup carbon fiber po sya.. medyo mahal sya compared sa mga honda at sa ibang kotse na may readily aftermarket parts kasi binayaran ko pa yung molde dahil walang available na ganyan ganun din sa skirts at bumper binili ko din yung molde nila.. so may molde na ako..

UltraRacing sa wak wak mandaluyong yung mga strutbars, swaybars etc..