Parts Price for Isuzu

[nelS]

Hi I have a set of Sportivo Headlamps together with bumpers and grill baka you want to consider an upgrade to your 2004 crosswind, if not contact Atly he has a spare I think.

Thanks sa offer sir kaya lang wala po budget as of this time. Subukan ko po ule kay sir Atly.

[nelS]

Hi I have a set of Sportivo Headlamps together with bumpers and grill baka you want to consider an upgrade to your 2004 crosswind, if not contact Atly he has a spare I think.

Thanks sa offer sir kaya lang po wala budget as of this time. Try ko po ule kay sir Atly. Thanks.

[baby_scar]

Isuzu trooper 4jx1 engine Parts

1) Aircon Compressor?
2) Front and Rear Brake Pads?
3) Oil & Fuel Filter?

How much do it cost if you buy in Car Store, not in CASA?
Shop with ISUZU Genuine Parts.

Thank You

[TholitzReloaded]

Isuzu trooper 4jx1 engine Parts

1) Aircon Compressor?
2) Front and Rear Brake Pads?
3) Oil & Fuel Filter?

How much do it cost if you buy in Car Store, not in CASA?
Shop with ISUZU Genuine Parts.

Thank You

Try Jayson's in Manila..

[fabilioh]

Those are OEM rims of the the 2002-2003 Crosswind XUV and XUVi variants.... thou that is considered "special" because it is in chrome finish. Those only came standard in silver (XUV) and gunmetal finish (XUVi) only.

Now since you mentioned you intend to purchase those (expensive for 23k; if I would purchase them, it would be no more than 20k) for your XTO, it would fit but would not look nice. The offset and width is patterned for a "Sporty" Crosswind; which has overfenders/fender flares. The XTO does not have those.... ergo, the rims would protrude the fenders.

Hope this helps.

Hi bob,

Would you know the offset of the 2000 hilander XTRM, planning to change the rims kasi. I know it's pcd114, and there are a lot of 2nd hand 114 rms in the market, not too sure though which ones will fit.

Thanks!

[baby_scar]

Try Jayson's in Manila..

sir . good evening. Pls send the address and telephone number of Jayson in Manila? they sell genuine isuzu parts? may kakilala ka doon? refer name? thanx

[tabuso286]

Offer ko sayo yung Hankuk brand na Shock Absorbers Made in Korea for your Hilander for only P650 each front and rear, fluid type.

I also have affordable suspension parts for Hilander. The brand is Atlas Made in Thailand. Balljoint Upper P420 each; Balljoint Lower P480 each; Rack End P350 each; Tie Rod End P415 each. Suspension parts are guaranteed and tested.

Just txt me at 09177448113 if your interested and to order the parts. You can pick up the parts here at Makati Cinema Square Mcdonalds.

Thank you.

Jay C.
09177448113

Sir available pa po ba itong mga parts na ito? interested po ako sa mga ball joint at iba pang pang ilalim na parts, need to replace these parts bago pa lumaki ang gastos hehehe, txted you already sir but no reply. Here's my number 09158067123 from makati lang din po ako

[red16]

Mga sir ok naba yung price na binigay sakin: (555 brand) Brand new-Center link 2.5k for xuv 02 model? kasi sira nadaw yung bolts o tie rod ends ba tawag dun?! Yung nasa Both side (dulo ng center link.) sa right sidedriver side, umaangat kapag kinakabig kuna yung manibila or pa repair kunalng sa Machine shope? Or mapapamahal pa ako pag pinagawa kupa!

Ano po ba the best nagamiting brand or solution sa mga RAIN STAIN or DROPS sa mga salamin. Ok ba yung paste type ng japan, kikiskisin mulang daw parang eraser?! 400php sa concorde malls.

[jaz014]

front bearing inner 280petot outer 250 petot koyo brand then 200 petot labor for repacking the front wheel.....kapag umugong pala na parang humming sound yung gulong it is possible na may sira na yung bearing...

[theonlyone]

tanong ko lang, baka alam nyo kung saan makakabili ng plastic handle sa pang-adjust ng recline ng driver seat. saka cover ng fusebox sa front bandang gilid driver side. my ride is sportivo 2007. sa isuzu kaya meron noon? o kung di sa casa, saan kayo meron?

[red16]

OPTIMUS or OPTIMUM(brand name ng Center link) for xuv xwind. Mga sir sounds familiar ba cnyo itong brand na ito? any comment and suggestion? Taiwan made daw!

[fabilioh]

Need to change driver's side spindle for my hi-lander, quote sa akin sa Jaysons 8k brand new, sa Banawe surplus naman 5k..ok na kaya surplus??

[red16]

Mga sir's.... Yesterday nag pa-ayos at pakabit ako ng sa 02 XUV:

* 4pcs. suspension bushing (left & right) upper front. 150 each by pressing so x 4 = 600
* Camber alignment. 800

* Labor. (400 per side or tire) 800

Total : 2200 pesos................

Oks ba mga sir yung binigay na price? O napamahal ako sa labor at pressing daw sa s.bushing? Bago open lang yung service center dito, kaya sinibukan ko yung service nila.

[TholitzReloaded]

Mga sir's.... Yesterday nag pa-ayos at pakabit ako ng sa 02 XUV:

* 4pcs. suspension bushing (left & right) upper front. 150 each by pressing so x 4 = 600
* Camber alignment. 800

* Labor. (400 per side or tire) 800

Total : 2200 pesos................

Oks ba mga sir yung binigay na price? O napamahal ako sa labor at pressing daw sa s.bushing? Bago open lang yung service center dito, kaya sinibukan ko yung service nila.

*Red16, Saan ka nagpagawa? I had a quotation from Servitek Araneta.

My quotation from Goodyear Servitek in araneta for the kabig problem.
SUSPENSION:
------------------------------------------
2 pcs. Upper Arm Bushing *750each - 1500 ---> Jayson's Manila Php280 each.
Machine Shop 500
Labor 450
------------------------------------------
ALIGNMENT:
Toe In/Out 320
Camber Correction 800
Caster Adjustment 220
------------------------------------------
OTHERS
4 pcs. SAIM 1/8 180 -> di ko natanong kung ano to.
------------------------------------------
Total Php3970

[red16]

*Red16, Saan ka nagpagawa? I had a quotation from Servitek Araneta.

My quotation from Goodyear Servitek in araneta for the kabig problem.
SUSPENSION:
------------------------------------------
2 pcs. Upper Arm Bushing *750each - 1500 ---> Jayson's Manila Php280 each.
Machine Shop 500
Labor 450
------------------------------------------
ALIGNMENT:
Toe In/Out 320
Camber Correction 800
Caster Adjustment 220
------------------------------------------
OTHERS
4 pcs. SAIM 1/8 180 -> di ko natanong kung ano to.
------------------------------------------
Total Php3970

* sir tholithz may PM ako cyo.

[TholitzReloaded]

* sir tholithz may PM ako cyo.

thanks, medyo malayo pala yung shop na pinagawaan mo. QC or Manila area lang ako. Anyway I think okay naman yung price mo di naman nalalayo sa quote sakin ng Goodyear Servitek sa Araneta.

[red16]

thanks, medyo malayo pala yung shop na pinagawaan mo. QC or Manila area lang ako. Anyway I think okay naman yung price mo di naman nalalayo sa quote sakin ng Goodyear Servitek sa Araneta.

ok! sir may alam ba kayong magandang pangtanggal ng rain stain or drops sa salamin ng car at headlight glass? thanks!

[yajter]

mga sir, saan ba makakabili ng crankshaft pulley ng 1996 model na pick up? Laguna ang location ko. Makalog na yung pulley, natatakot nga akong gamitin baka biglang bumigay.TIA

[ImagongPinoy]

Good Evening po, kakabili ko lang po ng 2003 crosswind xuvi, tanong ko lang po kung magkano ang exhaust manifold kasi may crack na. thanks

[s-one]

good day po sir., can i ask san po ba pwede makabili ng power window main switch ng isuzu fuego 97-99 at ng power window passenger side...kahit surplus basta orig at working condition....u can text 0920 437 1331 or pm me ...