Cruise control during break-in period

[StockEngine]

Used it in NLEX at 100kph which is fast

Kahit naman kasi di gumamit ng cruise, constant talaga speed at rpm sa nlex hehe

100kph is around 2000rpm(plus or minus 250rpm depeding on vehicle) its the sweetspot for most engines. thermal efficieny is near the peak.


120 is fast as it is away from the peak thermal efficiency...this should be avoided during break-in

[Wave24/7]

Don’t overthink it. Just drive normally and not like “drive it like you stole it” type.

Congrats and drive it in good health.

[kris_13]

Don’t overthink it. Just drive normally and not like “drive it like you stole it” type.

Congrats and drive it in good health.

Yes Sir, I just drive it the normal use. I asked this bec someone mentioned that it should be avoided haha.

In the first place, the manufacturers should have disabled cruise until you reach a thousand mile to enable cruise if it will destroy the engine.

I am new to AT cars, always drive a manual for many years. thanks

[Wave24/7]

You’ll likely damage the engine through overheating and not following proper oci.