I have a new project car...

I have Kicker 2 L712 dual voice coil 2/4oms
750rms Minimumum and 1500rms Max

and a profile ca1200 with 2 channels...
AMP Specs:
300 watts RMS x 2 at 4 ohms
450 watts RMS x 2 at 2 ohms
900 watts RMS x 1 bridged output at 4 ohms
4-ohm stable in bridged mode
stereo or bridged mono output

I know that the amp is underpowered for the L7s..

The question...
If I bridge the the AMP it will give me 900 watts RMS in 4oms power or lower. so I get atleast the minimum rms for the SUBs.

Now would it be better if I series the two SUBs for it? or just use the two channels for the SUBs.

Thus: two chnneling the AMP will only give me 450rms of power that is below the rms required for each SUB...

Thanks...