Remote cable...san ikakabit?

[baseview]

Last week nagpakabit po ako ng bagong HU at amplifier....after the sounds were set...nawala park lights/Tail lights ko...I brought my vehicle to an electrician and found out that the park lights/Tail lights wire were tapped to the remote of the HU...
Tanong ko na rin...ung dating stereo...kapag nakabukas ang park lights/Tail lights...nakabukas din ung ilaw ng stereo...ngaun...kahit naka-on ang park lights/Tail lights..walang ilaw ang HU...saka lang mabubuksan ilaw ng HU kapag naka-on na ang HU or nakadisplay ang time.

[funkngruvn]

yung remote wire ng stereo e kinakabit lang sa remote terminal ng amp o ng power antenna para pag on mo nung radio mag on na din ung amp/antenna, tapos magooff na din kapag off mo na yung radio, kumbaga yun yung switch ng auxiliary equipment..

[wildthing]

baseview...hindi marunong mag-install ng tama yung electrician mo...palitan mo suggest ko.

[viper2lt]

sa hu meron mismo nakalagay na power ant at power amp. kung remote cable, sa power amp ang kabit. yung lumang hu, meron talaga kasama cable yun para sa panel/tail lights. baka akala ng nagkabit, dun nakakabit ang remote kaya nag tap sya dun kasi for sure meron sya tinganggal na connection dun na kulay blue ang wire (usual color ng mga remote cable) at napagkamalan nya na remote yun. hth

[sharkgalant]

yung remote wire (usually the blue one) kinakabit sa remote ng amplifier or sa power antenna. yan ay para sumabay yung amp/antenna sa pag-on ng head unit.

yung sa parklight naka kabit. dimmer naman yun. purpose nun is to decrease the light from the face of the HU when its dark kaya sya naka-tap sa park lights.

hope this helps

[baseview]

yung remote wire (usually the blue one) kinakabit sa remote ng amplifier or sa power antenna. yan ay para sumabay yung amp/antenna sa pag-on ng head unit.

yung sa parklight naka kabit. dimmer naman yun. purpose nun is to decrease the light from the face of the HU when its dark kaya sya naka-tap sa park lights.

hope this helps

THanks for the replies...

Boss Shark....aling kulay naman po ng wire ng headunit ang ikakabit sa dimmer/park light? may napansin po kase akong black, red yellow at blue na cables ng HU.

[baseview]

yung remote wire (usually the blue one) kinakabit sa remote ng amplifier or sa power antenna. yan ay para sumabay yung amp/antenna sa pag-on ng head unit.

yung sa parklight naka kabit. dimmer naman yun. purpose nun is to decrease the light from the face of the HU when its dark kaya sya naka-tap sa park lights.

hope this helps

THanks for the replies...

Boss Shark....aling kulay naman po ng wire ng headunit ang ikakabit sa dimmer/park light? may napansin po kase akong black, red yellow at blue na cables ng HU.

Yung black cable ang ikinabit dati ng installer sa parklight...tapos nung dinala ko sa electrician, sa ground na lang nya nilagay...

Isa pa po...bakit po kaya naka-ground din ung isang RCA ng HU?

[sharkgalant]

sir what brand po head unit nyo?

black- ground
red - accessory
yellow - positive (bypassing ignition)
blue - remote

the rest ng wires na in pairs speaker wires na (high level output)

yung mga remaining wires pwedeng sa
-telephone muting
-dimmer

[baseview]

3950 lang po ng pioneerr...bigay lang po ng isang kaibigan..
so san po ang tamang wiring para kapag naka-on ang parklights/headlights ko eh naka-on din ung ilaw ng HU?
Ung stock po kase dati,kahit off ang HU,naka-on ang ilaw nila kapag naka-on ang mga parklights/headlights.

Slamat po bossing shark!

[baseview]

BTW...FUJITSU TEN,stock ng mitsubishi adventure po ung huling HU ko. eto ung colors ng cables nya..
ORANGE
RED
YELLOW
BLUE

Ung cables ng 3950....san ko po ita-tap?

TIA

[userfriendly]

Bring t to Banawe. Usually 200 pesos charge to install. Just make sure you deal with a store and not one of the tambays.

[OTEP]

Most of the time may label naman ang wires na iyan. I have no formal training sa ganyan but I did work on my former system (nabenta na).

I don't know how your installer messed it up so much to involve the exterior lighting of your vehicle. The remote wire on the Pioneer is clearly marked. Pioneer din nga pala head unit ko dati. Sumasabay din sa parklamps yung backlighting niya pero wala akong ganyang problems.

[sharkgalant]

BTW...FUJITSU TEN,stock ng mitsubishi adventure po ung huling HU ko. eto ung colors ng cables nya..
ORANGE
RED
YELLOW
BLUE

Ung cables ng 3950....san ko po ita-tap?

TIA

red on red
yellow on yellow
black sa body

im not familiar with the color coding of pioneer na sir. try searching for installations manuals sa internet

[v6dreamer]

Ang mga bagong H.U ngayon usually have more than one power wire- an accessory power lead and a memory lead, some have a third wire for display illumination.

Heres what you need to know:
Dalawang option in connecting the accessory power lead: SWITCHED ( hot only when ignition is keyed) or UNSWITCHED (power is supplied all the time). Bihira ang H.U will remain illuminated, even when you turn them off, if the accessory power lead is hooked to UNSWITCHED power. Kaya mas magaling kung ang H.U ay naka hooked sa switched power so they wont drain your battery. Pero kung decide mo na gusto mong gamitin ito make sure to turn off your H.U when park your car or you risk draning your batt. Hehehehehe

You can get unswitched power from a direct connection to the positive battery terminal or from fuse that always hot. Be careful not to tie in to a circuit that could cause noise problems: usually any circuit that have a motor or switch somewhere in thier path.

The MEMORY lead must be connected to an UNSWITCHED source or the H.U memory will be lost every time the car is cut off. Most H.U wont operate w/o the memory lead connected.

[baseview]

Problema ko na lang eh hanapin kung anong purpose nung mga wires!!