I'm looking for an RCA ground loop isolator locally

[oj88]

Such as this:



or this:

[img]http://ecx.images-amazon.com/images/I/41tm***Ap9L.jpg[/img]


Please point me in the right direction.

Thanks!

[Lew_Alcindor]

Curios lang. Anung advantage sa ordinary RCA cable?

[oj88]

Curios lang. Anung advantage sa ordinary RCA cable?

Ground Loop Isolators

[benchman]

*oj

are you having noise?

- - - - - - - - - - - - - - - - - - - - - -

*oj

are you having noise?

[oj88]

*oj

are you having noise?

- - - - - - - - - - - - - - - - - - - - - -

*oj

are you having noise?

Yeah, from the sub preouts to the powered sub. Vehicle noises, like computer buzzing, a bit of whining and pops when electrical loads in the car are turned on or off. Noises stop whenever I disconnect the preouts from the amp, so it's not the amp. No noises as well from the main speakers.

Checked all grounds and they're fine. I did found out that the amp RCA inputs have floating ground but not on the HU, so on the HU, the chassis ground and the preout/signal ground are common. So i've reason to beleive that there exists a ground loop.

[benchman]

aside from poor grounding system, check your RCA cables. never run/route your RCA along with any power cables. say if you have the RCAs laying on the left side of your car, run your power cable on the right then.
also check for stripped RCA insulators or there could be jammed/pinned RCA cable somewhere.

[StockEngine]

Yeah, from the sub preouts to the powered sub. Vehicle noises, like computer buzzing, a bit of whining and pops when electrical loads in the car are turned on or off. Noises stop whenever I disconnect the preouts from the amp, so it's not the amp. No noises as well from the main speakers.

Checked all grounds and they're fine. I did found out that the amp RCA inputs have floating ground but not on the HU, so on the HU, the chassis ground and the preout/signal ground are common. So i've reason to beleive that there exists a ground loop.

-how did you check the grounding? you can use a dvm(with fresh 9v batter) and all ground points should be 0.2 ohm
-the computer buzz/hum is the sound of coil whine in some motherboards or power supplies or videocards.

- - - - - - - - - - - - - - - - - - - - - -

Yeah, from the sub preouts to the powered sub. Vehicle noises, like computer buzzing, a bit of whining and pops when electrical loads in the car are turned on or off. Noises stop whenever I disconnect the preouts from the amp, so it's not the amp. No noises as well from the main speakers.

Checked all grounds and they're fine. I did found out that the amp RCA inputs have floating ground but not on the HU, so on the HU, the chassis ground and the preout/signal ground are common. So i've reason to beleive that there exists a ground loop.

-how did you check the grounding? you can use a dvm(with fresh 9v batter) and all ground points should be 0.2 ohm
-the computer buzz/hum is the sound of coil whine in some motherboards or power supplies or videocards.

[12vdc]

Problem may be solved by wiring another ground line direct from battery, hu power supply, shielded cables up to the last audio accessory. This works for me everytime i encounter noise.