Solarguard Tint

[tidus1203]

Had my Innova's front tinted with LX40. Same what I had with the Lexus IS. As usual, it was kinda pricey at P9K but ok lang its for the life of the car na...

[red_one]

*red_one

I'm really surprised that there is not a single post about the Ultra Performance (ceramic) series of SG in this thread. Wala bang nagaavail nun? I was quoted 14K for the 2018 Subaru XV. The available shades are VLT 10, 30, and 60. Any thoughts?

I looked at the specs and mas mataas ang TSER ng HP series. While ang UP series nanan mas walang interference sa RF and phone signals. So it depends na lang kung ano need mo.

Sent from my ASUS_X00DDA using Tapatalk

[kevindd992002]

I looked at the specs and mas mataas ang TSER ng HP series. While ang UP series nanan mas walang interference sa RF and phone signals. So it depends na lang kung ano need mo.

Sent from my ASUS_X00DDA using Tapatalk

Chineck ko nga din e. So anong advantage ng UP series over sa standard non-HP series nila? E parehas lang silang no signal interference?

Sent from my SM-G950F using Tapatalk

[red_one]

Chineck ko nga din e. So anong advantage ng UP series over sa standard non-HP series nila? E parehas lang silang no signal interference?

Sent from my SM-G950F using Tapatalk

UP series has higher TSER than non-HP.

HP = highest heat rejection, might have signal interference, metallic based
UP = higher heat rejection, no signal interference, ceramic based
Non-HP = heat rejection, no signal interference, dye based

Sent from my ASUS_X00DDA using Tapatalk

[kevindd992002]

UP series has higher TSER than non-HP.

HP = highest heat rejection, might have signal interference, metallic based
UP = higher heat rejection, no signal interference, ceramic based
Non-HP = heat rejection, no signal interference, dye based

Sent from my ASUS_X00DDA using Tapatalk

Ok, that makes more sensr. Thanks for clearing it up.

So what do you personally recommend? Is the Charcoal series the best compromise? Or is there even really signal interference with the Quantum series?

Sent from my SM-G950F using Tapatalk

[red_one]

Ok, that makes more sensr. Thanks for clearing it up.

So what do you personally recommend? Is the Charcoal series the best compromise? Or is there even really signal interference with the Quantum series?

Sent from my SM-G950F using Tapatalk

HP Quantum pa lang natry ko. I don't have RFID so cannot test signal interference. Pero radio and phone, no problem.

Sent from my ASUS_X00DDA using Tapatalk

[kevindd992002]

HP Quantum pa lang natry ko. I don't have RFID so cannot test signal interference. Pero radio and phone, no problem.

Sent from my ASUS_X00DDA using Tapatalk

Ok. What's your take between Solargard HP, Huper Optik, and Sunbloc Ceramic?

Sent from my SM-G950F using Tapatalk

[benru3tps]

HP Quantum pa lang natry ko. I don't have RFID so cannot test signal interference. Pero radio and phone, no problem.

Sent from my ASUS_X00DDA using Tapatalk

My picantos windshield has solargard hp quantum,unfortunately when i was buying RFID they were testing it and the rfid couldnt be read. My rfid ended up being attached to the headlight. [emoji24]

Sent from my SM-G935F using Tsikot Forums mobile app

[benru3tps]

Had mine installed this August to replace the tint that came from the casa.

Was quoted PHP 6.8k for the Fortuner 2016 in Solargard Santolan.

HP Charcoal 22 for all windows except windshield
HP Charcoal 43 for the (full) windshield since they don't have HP Charcoal 50.

So far, no signal interference - or at least my GPS and LTE still works fine.

HP Charcoal 43 is doing its job. So far, so good. My main purpose for getting it is the heat rejection. As mentioned above, I would've gotten the 50 if it was available because I like to see as much of the road as possible. The 43 is fine, but there is obviously noticeable shade due to the lower light transmittance. I don't really mind that people from the outside can see inside. My wallet wasn't willing to get the high-end clear tint for the windshield. :D

I was told that since HP series has some metals, it might be a problem for RFID signal. I don't have an RFID so I can't confirm the claim.

" .... was told that since HP series has some metals, it might be a problem for RFID signal. I don't have an RFID so I can't confirm the claim. "

It does pose a problem to rfid as what I quoted in my previous post. But no issue with cellphone signal,gps,LTE.

Sent from my SM-G935F using Tsikot Forums mobile app

[mar04]

Lumipat o wala na ba ung solargard sa alabang? Wala na ung pwesto nila pati ung ibang mga shop nung pag daan ko.