Interior/legroom lighting project using LED

[BlackPrince]

Folks,

Has anybody here tried DIY lighting project using LED in your rides? Please see this page for more information.
http://www.electronics-project-desig...rLEDLight.html

Thanks!

[glntVR]

I've been planning to have one installed in my car. Just don't have the time to have it done. I won't DIY it though. hehehe

I have warm white neons on my trunk and plan to transfer it under my dashboard and put warm white LEDs in my trunk to replace the neons.

My plan is to have it activated when the doors are open, but there would also be a switch to override it.

[BlackPrince]

Thanks glntVR.

Anybody who knows where to buy a printed circuit board (PCB) for this project? Suking Deeco can provide the ICs, LEDs and capacitors though. Anyone tried this project DIY style?

[OTEP]

I just use single contact bulbs for my footwell lamps. Cheap but does the job. Wired to the door sensor for automatic operation. Just had jameson put them in. About half an hour start to finish.

[Horsepower]

blackprince, you can buy a circuit board and design it as required.

[s_quilicot]

blackprince, you can buy a circuit board and design it as required.

HP, saan and how much?

[glntVR]

I just use single contact bulbs for my footwell lamps. Cheap but does the job. Wired to the door sensor for automatic operation. Just had jameson put them in. About half an hour start to finish.

Yup this is the way to go, cheap and easy solution. hehehe

Sir Otep, is Jameson a shop? Where is it located?

[BlackPrince]

Yup this is the way to go, cheap and easy solution. hehehe

Sir Otep, is Jameson a shop? Where is it located?

Sir Otep, thank you. btw - san po yung shop and how much?