Epoxy Enamel as undercoat

[seymorebutts]

hello!

anybody had tried this? can you please post some feedback.

i went to a shop which do undercoating and told me they use epoxy enamel as opposed to rubberized like 3m.

i dont know if its better or not.

please advise

[jjmd3_787]

My friend recommended it to me too. Ok naman daw ang rustproofing effectiveness at siyempre, mas makintab kaysa rubberized. Ang downside ay mas expensive ito kasi mas matagal ang preparation at process.

[seymorebutts]

thank you sir, but how about yung mga small stones na tumatama sa kanya nag ba bounce din kaya kagaya ng rubberized undercoat, hindi kaya mag chip o mag peel once tamaan ng bato?

salamat po ulit!

[Ginnova]

I removed the rubberized undercoat and replaced it with epoxy primer sa mga wheel wells. matibay yung epoxy primer. mas madali din linisin. yung ruberrized undercoat nag-peel off din at dirt magnet pa. havent tried yung epoxy enamel sa underside.Only tried painting some rusted parts using epoxy enamel and mas makintab nga sya.

[toxic03]

mga sir any one tried after rubberized undercoat patungan pa ng epoxy prime/enamel sa mga wells area. mas ok ba? any positive feedback. TIA

[seymorebutts]

mga sir any one tried after rubberized undercoat patungan pa ng epoxy prime/enamel sa mga wells area. mas ok ba? any positive feedback. TIA

i read somewhere na it will be useless kasi sa rubberized undercoat sya nakadikit, once matanggal na yung dikit ng rubberized uc, tanggal din yung epoxy.

pero lets wait for others na nakapag try na to comment.

[Ginnova]

Hindi pwede patungan yung rubberized undercoat ng epoxy primer/enamel. malulusaw yung rubberized undercoat. kailangan mo muna tanggalin yung 3m.

[toxic03]

i read somewhere na it will be useless kasi sa rubberized undercoat sya nakadikit, once matanggal na yung dikit ng rubberized uc, tanggal din yung epoxy.

pero lets wait for others na nakapag try na to comment.

may point ka sir. 3m alone nalang sigur0. maganda p effect sa suondproof.

[spyghost]

I removed the rubberized undercoat and replaced it with epoxy primer sa mga wheel wells. matibay yung epoxy primer. mas madali din linisin. yung ruberrized undercoat nag-peel off din at dirt magnet pa. havent tried yung epoxy enamel sa underside.Only tried painting some rusted parts using epoxy enamel and mas makintab nga sya.

what is the prep work for this? just remove the undercoat? how about the oem finish - retain it or scrape to metal?