Results 1 to 10 of 10
Hybrid View
-
Verified Tsikot Member
- Join Date
- Feb 2014
- Posts
- 112
March 8th, 2014 08:54 PM #1Mga fellow tsikoteers, noob question lng po. Paano po ba naapektuhan ng aircon ang fuel consumption? Pag nilakasan po ba ang blower lalakas din ang gas consumption? Pag tinataasan po ba ang thermostat lalakas din ang gas consumption? Please enlighten me guys regarding this matter. Thanks in Advance peeps.
-
Tsikot Member Rank 2
- Join Date
- Jun 2005
- Posts
- 3,774
March 8th, 2014 09:07 PM #2
-
Verified Tsikot Member
- Join Date
- Feb 2014
- Posts
- 112
March 8th, 2014 09:10 PM #3ibig sabihin sir, ung taas ng thermostat lvl at lakas ng blower ay hindi direktang nakakaapekto sa gas consumption? kumbaga inshort, basta umikot ang compressor lalakas sa gas, kahit naka low cool? tama po ba?
-
Tsikot Member Rank 2
- Join Date
- Jun 2005
- Posts
- 3,774
March 8th, 2014 09:26 PM #4minimal effect lang naman. but yes, you get the point.
Sent from my Thrill 430x using Tapatalk 2
-
Verified Tsikot Member
- Join Date
- Feb 2014
- Posts
- 112
March 8th, 2014 10:25 PM #5
-
Tsikoteer
- Join Date
- Mar 2008
- Posts
- 54,293
March 8th, 2014 10:39 PM #6you can actually feel the power drain when you turn on the aircon. you can feel the engine/car lurch just a little (suddenly slow down a little) if you aren't running fast... in some (older?) cars, you can read a drop of engine rpm..
the energy drain isn't too small.. up to 10% or so, some say... depending on the engine's size..
to compensate for this loss in engine power, there is the automatic idle-up circuit, and there's also your right foot..Last edited by dr. d; March 8th, 2014 at 10:41 PM.
-
Tsikoteer
- Join Date
- Nov 2009
- Posts
- 3,509
March 8th, 2014 11:32 PM #7Everything connected to the crank that is dragging its rotation consumes fuel.
More electrical loads/ Higher current draw = more resistance to alternator's rotational force.
Inclined roads, stop and go traffic, high-speed driving = more rotational force needed to move the flywheel.
Aircon compressor turned on = resistance in the pulleys. The lower the thermostat setting, the more and longer your compressor engages with the crank. The higher, does almost the same when your heater engages in a form of electrical load(heater coil).
-
Verified Tsikot Member
- Join Date
- Feb 2014
- Posts
- 112
March 10th, 2014 11:46 AM #8
Ongoing problem pa din Pala ito even among euro cars ...
Takata Airbag Problems