How can I place a long sticker on a round surface accurately?

**Harangody** · May 6th, 2012 02:55 PM

I need to put a 2" x 12" sticker on the rear glass.

**niky** · May 6th, 2012 03:37 PM

Measure off the spot you're putting it on with tape first.

**ghosthunter** · May 6th, 2012 04:03 PM

Originally Posted by Harangody

I need to put a 2" x 12" sticker on the rear glass.

You could ask tint installers to help you. At least with their method, you can still adjust the sticker to properly center it.

**raycon_24** · May 6th, 2012 04:18 PM

spray shampoo with water

**jick.cejoco** · May 6th, 2012 04:27 PM

use a sacrificial material like plastic film and fold it in half-this way you get the center if that's where you need it placed. then mark with a white board marker to mark the center. install the film sticker one side at a time just like what you do with "band aid". roll the tape a little at a time pushing out bubbles. if the film is not elastic enough, use a hair blower to warm the material and shape it to the surface you want it installed while the backing of the sticker is still on.

**chua_riwap** · May 6th, 2012 04:32 PM

baka problema rin ni TS on how to stick the sticker w/out the "kulubot".
kasi, pabilog yung surface. ang sticker maganda lapat pag flat yung surface.

i don't know kung isa yan sa issues nya......

**ghosthunter** · May 6th, 2012 04:47 PM

Originally Posted by chua_riwap

baka problema rin ni TS on how to stick the sticker w/out the "kulubot".
kasi, pabilog yung surface. ang sticker maganda lapat pag flat yung surface.

i don't know kung isa yan sa issues nya......

That is why its probably best to ask the help of some tint installers.

**Joe Magarac** · May 7th, 2012 12:21 PM

Put a markings on where you will place the sticker, spray the surface with shampoo mix with water, place the sticker while surface is still wet so you can move the sticker evenly and in place with ease. Let it dry, then wipe with clean smooth cloth. That's all.....

**Harangody** · May 7th, 2012 01:51 PM

Originally Posted by Joe Magarac

Put a markings on where you will place the sticker, spray the surface with shampoo mix with water, place the sticker while surface is still wet so you can move the sticker evenly and in place with ease. Let it dry, then wipe with clean smooth cloth. That's all.....

Thanks! This worked.

Thanks rin sa replies ng iba.