Results 1,111 to 1,120 of 1613
-
Verified Tsikot Member
- Join Date
- Mar 2010
- Posts
- 2,247
October 10th, 2013 08:31 AM #1111
-
Verified Tsikot Member
- Join Date
- Apr 2011
- Posts
- 198
-
Verified Tsikot Member
- Join Date
- Mar 2010
- Posts
- 2,247
October 12th, 2013 07:33 PM #1113
-
Verified Tsikot Member
- Join Date
- Nov 2008
- Posts
- 641
October 13th, 2013 07:52 PM #1114Yes Sir, meron sila per liter. Actually, mas kampante din ako nung naka bote
-
Verified Tsikot Member
- Join Date
- Mar 2010
- Posts
- 2,247
-
Verified Tsikot Member
- Join Date
- Sep 2011
- Posts
- 262
October 15th, 2013 09:10 PM #1116I suppose gabi mo ito kinunan w/o the lights on. gusto ko sanang mag post din ng image abt mine (pinalagyan ko din ng led lights), unfortunately ala kang makikita, all dark he he he. any idea kung ano dapat kong ikabit coz it seems mas malakas dapat na led lights dun fx ko? TIA
-
Verified Tsikot Member
- Join Date
- Apr 2011
- Posts
- 198
October 20th, 2013 04:54 PM #1117hallo mga ka tam2
SHARE KO LANG PO lately may post ako na bakit hard starting ang tam.fx diesel ko for a long travel about 3hrs.gang itulak nalang para mabuhay ulit ang makina.(good battery at alternator naman) starter pala ang culprit hehehe halos d na daw magcontact un linis lang
-
Verified Tsikot Member
- Join Date
- Apr 2011
- Posts
- 198
October 20th, 2013 05:03 PM #1118hello
Re:tam fx gl series dashboard
ask ko lang po kung san ang location nang mga screw at ilang screw ng tam fx gl.balak ko kasing kalikutin din ang ilaw ng panel board diy lang po kc tnx sa mga comment
-
Verified Tsikot Member
- Join Date
- Nov 2008
- Posts
- 641
October 21st, 2013 10:30 AM #1119Sir Greg,
Here's the dismantling steps on what I did on my GL dash:
1. Center Aircon vent - Remove 2 screws below, upper portion is just clipped
2. A/C control & Ashtray Frame - Remove 6 screws (3 below and 3 above)
3. Gauge / Stereo / Clock Frame - Remove 7 screws (3 below stereo and clock, 1 at clock, 2 above gauge and 1 at the left side most of left A/C vent)
4. Gauge Panel - 4 screws (2 above and 2 below)
After removing all the screws, you may now pull the gauge a little bit, then remove the speedometer cable and the electrical plugs at the back. Make sure that you hold on to connector latch upon pulling, not the wires. After you have dismantled all the cables, you can now see all the bulbs at the back.
-
Verified Tsikot Member
- Join Date
- Apr 2011
- Posts
- 198
Buhay na buhay ang BGC this evening. Bukas halos lahat ng restaurants. Sabi pa nung isang cashier...
Traffic!