New and Used Car Talk Reviews Hot Cars Comparison Automotive Community

The Largest Car Forum in the Philippines

Page 85 of 164 FirstFirst ... 357581828384858687888995135 ... LastLast
Results 841 to 850 of 1640
  1. Join Date
    Oct 2002
    Posts
    3,013
    #841
    Quote Originally Posted by djoverdose View Post
    alin dun bro? kung yung sa washer dito ko lang din sa tsikot nakita eh.

    if its about the muffler. very easy. just go under your pick up and make sure you have a size 14mm back wrench with you. locate the flange of your exhaust.

    nasa right side near the rear door mo ito. it only have 3 bolts. yun na. you can try to remove it para malaman mo yung feel pag wala yung muffler. kung tutuusin asteeg nga tunog pag wala. you get a low growl from the engine plus pag nag boost iba. ang bilis umangat ng rpm also the turbo whine is more audible even at 1.5K RPM.

    ang na notice ko lang at low speed ramdam mo talaga na mas magaan yung takbo. pero pag long distance, may time na pag shift mo ng gear(M/T) parang kulang pa sa bilis.

    hirap i explain eh. kasi since mas maluwag na tumakbo halos at 4th gear nasa 80KPH nasa 2k rpm ka palang pa spool palang yung turbo. kaya pag nag 5th gear ka it will go down to 1.8K RPM so medyo parang under gear bigla pero after you step on the gas few sec after ok na uli.

    kaya ginagawa ko pinapaspool ko muna yung turbo bago mag shift. nakaka panibago pero once naman nag spool yung turbo ramdam mo yung hatak.

    specially kung naka drop in filter ka pa.

    I hope na medyo mas tumipid ako sa krudo ngayon. since pag hindi highway driving eh below 2K RPM lang lagi takbo ko at ok na yung speed niya.
    sir,

    baka you can post pictures of this modification so i can give it a shot, i read also in other forums that going to a 3inch pipe is overkill and the beast is for a 2.5inch pipe to maximize power......

  2. Join Date
    Apr 2009
    Posts
    280
    #842
    Sir Dadz,

    Thank you for the information sir.... hindi ba mabyby-pass yung boost cut off kung sakaling mag lagay ng manual boost controller?

    kasi diba po parang i-bynabypass niya mismo yung selinoid sa wastegate? ive also read na yung 3" nga po is overkill na. some say max will be 2.75".

    if budget permits gusto ko sana mag palagay ng chip. kaso yung mga available dito ang mamahal. not unlike nung mga nakikita ko sa net less than 20K.

    lastly sir have you tried replacing the stock IC tubings with solid pipes?

    KCboy,

    as per request.

    stock muffler taken out. actually maski ito lang puwede na. ganda ng growl ng strada nung tinangal ko ito.
    as you can see di ko pinagalaw yung stock muffler para puwede ko pa i-balik afterwards.
    nag pakabit lang ako ng resonator para stock yung tunog pero you can really hear the turbo whistling.



    from 18" down to 10" yung length ng resonator and still tunog stock halos. gusto ko sana magkaroon ng konting grunt pero mukang kelangan mas maikis pa dito or totally tangalin ko na yung
    resonator. pero difference niya mas masipol na yung turbo compared nung naka 18" ako. pero kung wala ito, talagang dinig na dinig mo yung spool ng turbo specially pag nag decelerate.


    Also nag pagawa din ako ng bagong flange para di nila putulin yung stock exhuast at para bolt on parin.

    pag nag ka oras will replace the remaining exhuast from the catalytic converter to the resonator ng 2.5" straight.



    pero sa mod palang na ito malaki na ang improvement. specially pag nasa highway. what ive observed likewise pag nasa 4th gear ako usually shift kana to 5th gear pag dating ng 80KPH though kaya naman sa 4th gear sagad till 100kph before shiting
    ngayon at 80KPH/4th gear nasa 2,000RPM lang ako. kaya pag umapak pa ako ng konti dun palang mag boboost yung 80-100KPH ng 4th gear halos di pa galit yung makina. at the same time pag shift mo ng 5th gear 100-120kph para mo lang pinipitik yung accelerator kasi once nag boost yung turbo hahatakin ka uli.

  3. Join Date
    Jun 2008
    Posts
    1,105
    #843
    The red marks po is the heheheheheheh

    Quote Originally Posted by djoverdose View Post
    Sir Dadz,

    Thank you for the information sir.... hindi ba mabyby-pass yung boost cut off kung sakaling mag lagay ng manual boost controller? NO sir hindi po siya ma bypass nag controller kasi even na full open yung controller pag nag boost the yung mapsensor pa din ang masusunod.

    kasi diba po parang i-bynabypass niya mismo yung selinoid sa wastegate? ive also read na yung 3" nga po is overkill na. some say max will be 2.75".
    Tama po sir 2.5 nga lang eh solve na mine is only 2.5

    if budget permits gusto ko sana mag palagay ng chip. kaso yung mga available dito ang mamahal. not unlike nung mga nakikita ko sa net less than 20K.There are a lot of choices sir just be sure kung anong type nag performance ang gusto mo.

    lastly sir have you tried replacing the stock IC tubings with solid pipes?
    My IC tubeing is alumimum 2.5 inch intake and a bit bigger intercooler po sir.
    KCboy,

    as per request.

    stock muffler taken out. actually maski ito lang puwede na. ganda ng growl ng strada nung tinangal ko ito.
    as you can see di ko pinagalaw yung stock muffler para puwede ko pa i-balik afterwards.
    nag pakabit lang ako ng resonator para stock yung tunog pero you can really hear the turbo whistling.



    from 18" down to 10" yung length ng resonator and still tunog stock halos. gusto ko sana magkaroon ng konting grunt pero mukang kelangan mas maikis pa dito or totally tangalin ko na yung
    resonator. pero difference niya mas masipol na yung turbo compared nung naka 18" ako. pero kung wala ito, talagang dinig na dinig mo yung spool ng turbo specially pag nag decelerate.


    Also nag pagawa din ako ng bagong flange para di nila putulin yung stock exhuast at para bolt on parin.

    pag nag ka oras will replace the remaining exhuast from the catalytic converter to the resonator ng 2.5" straight.



    pero sa mod palang na ito malaki na ang improvement. specially pag nasa highway. what ive observed likewise pag nasa 4th gear ako usually shift kana to 5th gear pag dating ng 80KPH though kaya naman sa 4th gear sagad till 100kph before shiting
    ngayon at 80KPH/4th gear nasa 2,000RPM lang ako. kaya pag umapak pa ako ng konti dun palang mag boboost yung 80-100KPH ng 4th gear halos di pa galit yung makina. at the same time pag shift mo ng 5th gear 100-120kph para mo lang pinipitik yung accelerator kasi once nag boost yung turbo hahatakin ka uli.

  4. Join Date
    Apr 2009
    Posts
    280
    #844
    Dadz,

    Great..... whats the noticeable improvement after replacing the stock piping? boost wise is it more constant? was really thinking of doing this mod next.

    also do you have any idea how to properly size an intercooler? though my friend told me that the stock IC is already sufficient.

    with regards with the chip, im having this thought that the chips that are being sold here are just like the HID's that are flooding the market today.

    different prices different claims but almost all of them are just the same inside. they just put their own stamp on the unit and thats it.

    any recomendations?

    lastly, ive read about the scan gauge, looks like this is a good kit. can it read fuel consumption? it is also a good alternative rather than installing a couple of gauges on top of the dash.

  5. Join Date
    Dec 2009
    Posts
    10
    #845
    Quote Originally Posted by Spoileddux View Post
    Sir, wala naman dapat palitan sa mga pangilalim ng truck mo if ever magpapalit ka ng tires pero kung gusto mo naman tumaas pa yung truck mo pwede mo palift mo na lang. I hope this would help sir...
    Hi sir, thanks for the info.

  6. Join Date
    Jun 2008
    Posts
    1,105
    #846
    Changing your piping and intercooler goes together but if your boost is standard the stock set up is fine no need to change if you boost is a bit higher a good size inter cooler is needed like if your boost is about 20 to 25psi 19.5X11X2.5 is good but if your boost is above the a 24X12X3 is okay too. But i do agree with your friend the stock IC is good enough for our engine.

    Chip is available in all system but you need to be sure on what your are getting. I have some chips too kaya medyo bias ako hehehehehehehehe it would be better to ask people with chips check out some forum and other sites in the internet. If you have time try to ask GO1 he is using a fully programable chip, Jashty Enzo is using a pre tuning chip and Sir Aldo he is using a injectors preset chip.

    The smart Gauge is a perfect gauge for us it rears every thing the ECU is reading, but sorry to say it dont show the FC because a slight change in tire size and driving habits changes the FC. It is always better to compute it manualy to get a good assement.

    Quote Originally Posted by djoverdose View Post
    Dadz,

    Great..... whats the noticeable improvement after replacing the stock piping? boost wise is it more constant? was really thinking of doing this mod next.

    also do you have any idea how to properly size an intercooler? though my friend told me that the stock IC is already sufficient.

    with regards with the chip, im having this thought that the chips that are being sold here are just like the HID's that are flooding the market today.

    different prices different claims but almost all of them are just the same inside. they just put their own stamp on the unit and thats it.

    any recomendations?

    lastly, ive read about the scan gauge, looks like this is a good kit. can it read fuel consumption? it is also a good alternative rather than installing a couple of gauges on top of the dash.

  7. Join Date
    Nov 2008
    Posts
    1,176
    #847
    Quote Originally Posted by dadz View Post
    The red marks po is the heheheheheheh
    pakner musta na.......ayos ba jan......

  8. Join Date
    Jun 2008
    Posts
    1,105
    #848
    Quote Originally Posted by mdksael View Post
    pakner musta na.......ayos ba jan......
    Pakner ayos naman eto puro trabaho baka balik ako nag pinas sa may for the transportshow ikaw pakner kamusta na mga alaga natin sa lomihan hehehehehehehehehe

  9. Join Date
    Jun 2007
    Posts
    3,957
    #849
    ^Siguradong malulusog pa rin yung mga alaga ni pakner mo sir dadz.....

  10. Join Date
    Feb 2006
    Posts
    469
    #850
    sir dadz nagpaparating pa po ba kyo ng rear anti sway bars for vigo and triton?

TSCP Strada Mods [continued 2]