Bakit ka badtrip today?

[travajante]

Still single phase bro. Demand just rose some 30KW.

Perhaps your area has no capacity surplus.

Sent from my SM-G970F using Tapatalk

[maxpedition]

3 phase ka na tutal magdedeposit ka sa knila then you can convert your load to single phase. At least 3 phase na yung line side mo.

Sent from my SM-G955F using Tapatalk

[travajante]

3 phase ka na tutal magdedeposit ka sa knila then you can convert your load to single phase. At least 3 phase na yung line side mo.

Sent from my SM-G955F using Tapatalk

+1

Sent from my SM-G970F using Tapatalk

[CVT]

3 phase ka na tutal magdedeposit ka sa knila then you can convert your load to single phase. At least 3 phase na yung line side mo.

Sent from my SM-G955F using Tapatalk

It's actually a good point bro,- and a WYE configuration should be the case for you to have an option for a single-phase Line-to-Line or Line-to-Neutral.... However, depends on the voltage requirements of your equipment...

Pero,- di ba dapat balanced ang 3 phases? Will your wiring be tailored for this? Or, the balancing will be left with Meralco?

[maxpedition]

It's actually a good point bro,- and a WYE configuration should be the case for you to have an option for a single-phase Line-to-Line or Line-to-Neutral.... However, depends on the voltage requirements of your equipment...

Pero,- di ba dapat balanced ang 3 phases? Will your wiring be tailored for this? Or, the balancing will be left with Meralco?

30kw load for a single phase mataas yun. Some equipments now when above 6kw need 3 phase power source. Meralco will only balance yung line side nila. Sa load side yung building owner na. 3 wires *110v each.

Sent from my SM-G955F using Tapatalk

[Wh1stl3r]

Perhaps your area has no capacity surplus.

Sent from my SM-G970F using Tapatalk

Yep looks like it. Malas

3 phase ka na tutal magdedeposit ka sa knila then you can convert your load to single phase. At least 3 phase na yung line side mo.

Sent from my SM-G955F using Tapatalk

Gonna talk to the Meralco guy next week. What's the benefit of getting 3 phase vs single phase if I have no plans yet of getting any 3 phase equipment in the near future? There is one piece that I'm considering that requires 3PH but I'm still studying the feasibility/ROI of that. That piece is so expensive it can already buy me a solar panel system for most of the roof.

[minicarph]

Dati nun may business pa ako and I had like 40 computers per store, nag-aaway pa nga kami nun Mall kasi gusto nyo pa convert ko sa 3 phase yun pinrovide nyan single phase.

Tapos nun nag 3 phase na ko finally laki ng binaba ng kuryente ko pero single phase pa din sa loob ha , 3 phase lang yun main

Nun nga sinars ko yun shop eh, i kept that big 3 phase main breaker parang sinlaki na din ng maliit na cabinet tapos advertise ko sa olx, wala pa 3 days may buyer na kagad, fil chinese din businessman

[CVT]

Tapos nun nag 3 phase na ko finally laki ng binaba ng kuryente ko pero single phase pa din sa loob ha , 3 phase lang yun main

Bro, I do not understand. Power is power and so could not be significantly saved nor created with a change in power configuration from single phase to three phase.

Can you please elaborate?

[Brentt]

Bro, I do not understand. Power is power and so could not be significantly saved nor created with a change in power configuration from single phase to three phase.

Can you please elaborate?

In a 3 Phase power delivery each line is energized and you will need to use two line to get the needed voltage. Power is distributed to three wires instead of two on single phase therefore more power can be delivered to the load.


Sent from my iPhone using Tapatalk

[CVT]

In a 3 Phase power delivery each line is energized and you will need to use two line to get the needed voltage. Power is distributed to three wires instead of two on single phase therefore more power can be delivered to the load.


Sent from my iPhone using Tapatalk

I understand that bro, you give more power because the three phases are just 120deg apart,- that's the main intention of a 3 phase power. (Vs a single phase where power is practically starved for 1/2 of the cycle,- 180deg)... Of course, the "relatively thinner wires" of the 3 phase vs 1 phase on the same power requirement.

What I do not comprehend is bro.minicarph's statement that "malaki binaba ng kuryente ko" sa 3 phase.... It cannot be true, because power in is just power out... There cannot be a creation of power with just a change in the transformer configuration (a "passive" component)....

[minicarph]

Bro, I do not understand. Power is power and so could not be significantly saved nor created with a change in power configuration from single phase to three phase.

Can you please elaborate?

yun kasi single phase na naka-abang from them ginamit ko ng 2 years, yun pala nineteen kopong kopong wire na yun, so maliit yun wire sa konsumo ko, lagi nag-iinit yun wire. yun sabe nun buset na engineer ng mall, so bale I average like 12K / month sa bill nuon., nun ginawa ng 3 phase yun braker as well as bago yun mga wires up to the electrical room ng mall, naging 6K/month na lang bill ko noon, same mga electricals , actually di pa nga kasi gumamit pa ng mga halogens sa bago renovation

so ang suspetsa ko pag 3 phase , hinde gano stressed ang wires therefore mas optimal daloy ng kuryente. hinde nam

[CVT]

yun kasi single phase na naka-abang from them ginamit ko ng 2 years, yun pala nineteen kopong kopong wire na yun, so maliit yun wire sa konsumo ko, lagi nag-iinit yun wire. yun sabe nun buset na engineer ng mall, so bale I average like 12K / month sa bill nuon., nun ginawa ng 3 phase yun braker as well as bago yun mga wires up to the electrical room ng mall, naging 6K/month na lang bill ko noon, same mga electricals , actually di pa nga kasi gumamit pa ng mga halogens sa bago renovation

so ang suspetsa ko pag 3 phase , hinde gano stressed ang wires therefore mas optimal daloy ng kuryente. hinde nam

Bro minicarph, iyong nag-iinit na mga wires will not consume approx 550KW-Hr per month (which is approx P6K per month in electric bill)

Malamang may mga naka-tap sa linya mo nuong 1phase ka pa, at na correct nila nuong na convert ka sa 3phase...

[_Cathy_]

I want to go ballistic!!! I hate it pag pinapakialaman ng Mommy ko mga gamit ko!!! I can't find ALL my gym clothes. Nilipat na naman ng cabinet tapos papagalitan ako I have too much stuff. So now what do I wear trekking?!?!? NOTHING!!!! I have no time to buy clothes!!! And to wear for one day! I swear I'm gonna lock all my stuff pag alis ko!!!

Sent from my SM-N960F using Tapatalk

[StockEngine]

I want to go ballistic!!! I hate it pag pinapakialaman ng Mommy ko mga gamit ko!!! I can't find ALL my gym clothes. Nilipat na naman ng cabinet tapos papagalitan ako I have too much stuff. So now what do I wear trekking?!?!? NOTHING!!!! I have no time to buy clothes!!! And to wear for one day! I swear I'm gonna lock all my stuff pag alis ko!!!

Sent from my SM-N960F using Tapatalk

mam you mom is bionic! shes fast!

[12vdc]

Nun nga sinars ko yun shop eh, i kept that big 3 phase main breaker parang sinlaki na din ng maliit na cabinet tapos advertise ko sa olx, wala pa 3 days may buyer na kagad, fil chinese din businessman

FilChi ka pla OB.

[12vdc]

Yep looks like it. Malas



Gonna talk to the Meralco guy next week. What's the benefit of getting 3 phase vs single phase if I have no plans yet of getting any 3 phase equipment in the near future? There is one piece that I'm considering that requires 3PH but I'm still studying the feasibility/ROI of that. That piece is so expensive it can already buy me a solar panel system for most of the roof.

3P motor and transformers runs efficiently than 1phase. If you have escalator/ elevator in your building and large motor then better use 3phase.

[minicarph]

FilChi ka pla OB.

hinde kaya ko pala nasabi na din, kasi nauna na may bumile ng electric meter na pang 3-phase, fil chinese din. so bale 2 fil-chinese businessmen binile yun electric meter na 3 phase, saka 3 phase circuit breaker

[minicarph]

Bro minicarph, iyong nag-iinit na mga wires will not consume approx 550KW-Hr per month (which is approx P6K per month in electric bill)

Malamang may mga naka-tap sa linya mo nuong 1phase ka pa, at na correct nila nuong na convert ka sa 3phase...

ganun. ewan ko ba yan yun mga panahon na napagloloko ako sa business eh kasi hinde naman ako electrician, contractor, renovator, pati nga fire extinguisher bumibile ako sa tiga -city hall tipong 10k isa, mantakin mo yun tapos fire extinguisher sa ace hardware 2k lang

kaya sinusumpa ko QC, never na ako babalik dyan and do business. dito na lang ako Ortigas and BGC and Makati, mas sosyal pa mga tao. yun nga lang madami maganda sa QC

[12vdc]

Kwwa ka naman OB pati metro sinalo mo, diba dapat kay Meralco yan dahil nka calibrate at seal?

[minicarph]

Kwwa ka naman OB pati metro sinalo mo, diba dapat kay Meralco yan dahil nka calibrate at seal?

sa mall kasi kelangan may sarile ka metro sa loob ng store mo, iba pa yun sa electrical room ng mall kung nasaan yun totoo metro. submetered ba term dun, kasi ang bayad ko sa kuryente sa mall hinde diretso sa meralco