Results 11,551 to 11,560 of 12058
-
Tsikot Member Rank 2
- Join Date
- Jan 2008
- Posts
- 4,726
December 7th, 2020 11:06 PM #11551
-
December 8th, 2020 10:50 AM #11552
-
Verified Tsikot Member
- Join Date
- Sep 2012
- Posts
- 19
December 30th, 2020 02:05 PM #11553Driver side door wont lock fully, yung iba ok naman, but pulling the driver side door handle while the car is locked will unlock the car. Last year, car figured in accident, was sideswiped by delivery truck leading same door being replaced with new one, not sure kung pati yung nasa loob ng door bago din. Pero bago lumabas yung problem, had Mr. Quickie duplicated the door key just for emergency (twice na kasi nalock ang susi sa loob). Then couple of days later pa bago lumabas ang problem. Had asked casa, 2500 daw baklas + diagnosis. M3 1.5 2015 here.
-
December 30th, 2020 03:28 PM #11554
The door cable connector may not have been re-seated securely into the notch near the door lever. Everything there is mechanical. To check, you'll have to remove the door card. Save your P2500. DIY it using this guide: How to remove take off Front door panel 2013-2018 Mazda 3 - YouTube
- - - - - - - - - - - - - - - - - - - - - -
The door cable connector may not have been re-seated securely into the notch near the door lever. Everything there is mechanical. To check, you'll have to remove the door card. Save your P2500. DIY it using this guide: How to remove take off Front door panel 2013-2018 Mazda 3 - YouTube
-
Verified Tsikot Member
- Join Date
- Sep 2012
- Posts
- 19
December 31st, 2020 08:31 AM #11555[QUOTE=travajante;3223066]The door cable connector may not have been re-seated securely into the notch near the door lever. Everything there is mechanical. To check, you'll have to remove the door card. Save your P2500. DIY it using this guide: How to remove take off Front door panel 2013-2018 Mazda 3 - YouTube
- - - - - - - - - - - - - - - - - - - - - -
There seem no problem with the cable connector.
When try push the lock, something pulling it back and then parang may small motor sound like rotating coming from this side of below pic.
-
December 31st, 2020 09:43 AM #11556
-
Verified Tsikot Member
- Join Date
- Sep 2012
- Posts
- 19
December 31st, 2020 01:44 PM #11557[QUOTE=travajante;3223085]Thanx sir Travs, Im not sure what the problem is, hindi ko matanggal yung actuator coz door lock cylinder is in the way but upon reassembly ok na sya.
Btw, how is door lock cylinder connected to actuator? Is it by gear or something? coz cant find any and physical key cant lock/unlock the car anymore.
-
December 31st, 2020 03:41 PM #11558
[QUOTE=yangmen;3223092]Good job! You may have gotten the cable end to properly get seated upon door card removal/reassembly.
The physical key mechanically unlocks the latch via linkage rod. To understand the basics of the automotive door lock system, check this clip:
How Power Door Locks Work - YouTube
-
Verified Tsikot Member
- Join Date
- Sep 2012
- Posts
- 19
January 6th, 2021 08:15 PM #11559Had my pms recently and as advised did a la carte.
Kindly share where to source & have cabin & air filter replaced aside from Golden Isuzu, preferably Cavite area. Or ok ba yung nasa Lazada? Cheaper than Casa which cost 5k for both.
Also, casa recommended to have the rotor resurfaced which I also skipped. Can someone recommend shop to have it done?
-
January 15th, 2021 08:53 PM #11560
Drive+ at QC provides brake rotor resurfacing services. Haven't availed their services yet but plan to.
Drive+ Car Care Center
Buhay na buhay ang BGC this evening. Bukas halos lahat ng restaurants. Sabi pa nung isang cashier...
Traffic!