Results 1 to 9 of 9
-
March 30th, 2008 01:54 PM #1
What do you think is best way for engine swapping a k20a halfcut dc5 or just buy the engine only?
Thanks.Last edited by gearspeed; March 30th, 2008 at 02:08 PM.
-
March 30th, 2008 07:31 PM #2
may nakita ka na? if im not mistaken its been years since nung nagtanong ka tungkol sa k20.
ewan ko lang, pero may mga alam ako engine lang ung kinukuha eh. hintay na lang natin reply ng iba.
-
March 30th, 2008 07:53 PM #3
IIRC a half cut gets you the wiring harness along with the transmission as opposed to just the engine.
-
BANNED BANNED BANNED
- Join Date
- Jul 2003
- Posts
- 2,267
-
Tsikot Member Rank 2
- Join Date
- May 2004
- Posts
- 903
March 31st, 2008 09:58 AM #5
-
March 31st, 2008 11:31 AM #6
If the halfcut also contains more parts than just the engine then you have spares to use.
I think you mean what's the best way to acquire a K20, not best way of swapping. It might be too dangerous to weld the front clip from a half-cut into a project car.
-
Verified Tsikot Member
- Join Date
- Aug 2003
- Posts
- 120
March 31st, 2008 11:42 AM #7AFAIK, they no longer allow half-cut importations na.. so more likely just engine with parts rather than the whole half-cut.
-
March 31st, 2008 12:28 PM #8
Halfcut wala pa pero k20a meron kaso yung iba na nakita ko PRC embed pero PRB ang tranny.Meron naman sa ibang shop PRC nga pero dun sa tranny wala yung sticker kung PRC.
Yung nakita ko pa sa iba meron nga straight PRC pero yung sticker parang kinabit lang at baka binuo lang.
How much does a halfcut dc5 cost?
Yung conversion kit wala pa din kaya antay pa rin ako.
Once na dumating na yung kit from dun dere derecho na.
-
BANNED BANNED BANNED
- Join Date
- Jul 2003
- Posts
- 2,267
that may be, but we all got plastic, young and old. we asked the lto guy, "papel ba po, o...
Driver's License Renewal Process?